Test WI ch.5

The type of weld produced by filling an elongated hole in an overlapping member fusing it to the member beneath is called a

Slot weld

The type of weld having a generally triangular cross-section, and which is applied to either a T corner or lap joint is called a

Fillet weld

In a single V groove weld the sloped surfaces against which the weld metal is applied are called

Groove face

The type of weld applied to the opposite side of a joint before a single V groove weld is completed on the near side of a joint is called a

Backing weld

The technique used to control distortion of a long joint where individual passes are applied in a direction opposite. The general progression of welding in the joint is called.

Backstepping

A technique used in a multiple layer will deposit were each successive layer is longer than the previous one is called

Cascade sequence

When looking at the cross-section of a completed, groove weld the difference between the fusion face, and the world interface is called the

Depth of fusion

The portion of the joint were the two pieces to be joined. Come, closest together is referred to as the.

Joint root and root face

The type of joint formed when the two pieces to be joined, are aligned in parallel planes, and their edges overlap is called

Lap

In a partial penetration, single V groove weld the dimension measure from the joint root to the weld root is called the

Root penetration

The size of a spot weld is determined by its

Spot diameter

The type of weld used to build up, send surfaces provide a layer of corrosion protection, provide a layer of abrasion resistant material is referred to as a

Surfacing weld

In the performance of a vertical position weld, the type of weld progression having a side to side motion is called

Weave bead technique

In a completed, groove weld the surface of the weld on the side from which the welding was done is called the

Weld face

The height of the weld above the base metal in a groove weld is called the

Weld reinforcement

In a completed weld the junction between the weld face, and the base metal is called the

Weld toe

Which of the following is not considered a type of joint?

fillet

For a concave fillet weld which throat dimensions are the same

actual, effective

In a fillet weld the leg and size are the same for what type of configuration

convex