Cad 139 module 3 test
A chamfer that is the same distance from the corner in each direction has an angle of ____. 30° 45° 60° 90°
45° Correct
Chapter 13 - Which of the following commands allows you to copy properties quickly from one object to another? COPY EXPLODE MATCHPROP PROPERTIES
MATCHPROP
After accessing the STRETCH command, you should use a fence to select the objects to be stretched. True False
False
An annotative dimension can have only one annotative scale applied to it. True False
False
Chapter 12 - When using the ROTATE command, if you specify a negative angle, the object rotates counterclockwise. True False
False
If two lines do not meet at a corner, they cannot be filleted. True False
False
The FILLET command can be used to create both inside and outside rounded corners. True False
True
Two polylines can be joined if they have a common endpoint. True False
True
Which keyboard key can you press while the TRIM command is active to access the EXTEND command? [Alt] [Ctrl] [Shift] [Tab]
[Shift]
Holding down the [Shift] key while the EXTEND command is active accesses the TRIM command. True False
True
What is the command that allows a pattern to follow an object such as a spline? PATHARRAY OBJECTARRAY ARRAYOBJECT ARRAYPATH
ARRAYPATH
Chapter 13 - Grips can be used to perform all of the following commands except ____. ARRAY COPY ROTATE SCALE
Array
Which of the following commands can be used to separate a single object into two objects? BREAK EXTEND JOIN TRIM
Break
Chapter 17 - Which of the following commands allow you to create a linear dimension line at the same angle (parallel to) as a slanted line? DIM and DIMALIGNED DIM and DIMANGULAR DIM and DIMJOGLINE DIM and DIMLINEAR
DIM and DIMALIGNED
Chapter 17 - Which command allows you to dimension the vertical distance between the endpoints of a slanted line? DIMALIGNED DIMANGULAR DIMJOGLINE DIMLINEAR
DIMLINEAR
The SCALE command increases or decreases the display of an object on-screen without affecting the object's actual dimensions. True False
False
How are all grip editing options shown? Left click the grip Hover over the grip Right click the grip Drag the grip
Hover over the grip
Chapter 12 - To draw a symmetrical assembly, you can draw one-half of the assembly and use the ____ command to reflect the first half to create the second half. ALIGN ARRAY COPY MIRROR
Mirror
Chapter 12 - Which command would you use to change the location of an object in a drawing without otherwise changing the object in any way? ARRAY COPY MOVE ROTATE
Move
Chapter 14 - A closed 2D area that can have physical properties such as centroids and moments of inertia is a ____. circle polyline region spline
Region
Chapter 12 - A mirror line can be placed at any angle.
True
Chapter 12 - Once activated, the COPY command remains in operation until you end the command. True False
True
Chapter 13 - The MATCHPROP command applies the properties of a source object to a destination object. True False
True
Chapter 13 - To remove items from a selection set, you can press and hold the [Tab] key while you pick the objects to remove. True False
True
Chapter 17 - If you access the QDIM command and select multiple objects, AutoCAD draws linear dimensions to the endpoints of every line and the center of every circle. True False
True
Chapter 17 - You can select a line to dimension without selecting its endpoints using the DIM command. True False
True
Chapter 18 - Multileaders can be annotative. True False
True
Chapter 18 - Measurements made with the DIMORDINATE command automatically originate from the ____. current UCS origin drawing limits lower-left corner of the screen WCS origin
current UCS origin
The size of a fillet in AutoCAD is determined by the ____. (1pts) angle of the filleted sides diameter of the fillet length of the filleted sides radius of the fillet
radius of the fillet