CHAP 6 EXAM

Which type of static route that is configured on a router uses only the exit interface?

directly connected static route

Refer to the exhibit. The network administrator needs to configure a default route on the Border router. Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?

Border(config)# ip route 0.0.0.0 0.0.0.0 s0/0/1

Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 How would an administrator test this configuration?

Manually shut down the router interface used as a primary route.

Which three IOS troubleshooting commands can help to isolate problems with a static route? (Choose three.)

PING, SHOW IP INTERFACE BRIEF AND SHOW IP ROUTE

Which two statements describe classful IP addresses? (Choose two.)

The number of bits used to identify the hosts is fixed by the class of the network. AND All subnets in a network are the same size.

What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state?

The static route is removed from the routing table.

What would be the best summary route for the following networks? 10.50.168.0/23 10.50.170.0/23 10.50.172.0/23 10.50.174.0/24

10.50.168.0/21

A company has several networks with the following IP address requirements: IP phones - 50 PCs - 70 IP cameras - 10 wireless access points - 10 network printers - 10 network scanners - 2

172.16.0.0/24

Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)

A(config)# ip route 10.0.0.0 255.0.0.0 192.168.1.2 AND A(config)# no ip route 10.0.0.0 255.0.0.0 172.16.40.2

Refer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?

A(config)# ip route 192.168.5.0 255.255.255.0 192.168.3.2

Refer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?

Configure a static default route from R1 to Edge, a default route from Edge to the Internet, and a static route from Edge to R1

What type of route allows a router to forward packets even though its routing table contains no specific route to the destination network?

DEFAULT

Refer to the exhibit. The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue?

R1 needs a static route to the R2 LAN.

Refer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?

R1(config)# ipv6 route ::/0 G0/1 fe80::2

The network administrator configures the router with the ip route 172.16.1.0 255.255.255.0 172.16.2.2 command. How will this route appear in the routing table?

S 172.16.1.0 [1/0] via 172.16.2.2

What are two advantages of static routing over dynamic routing? (Choose two.)

Static routing is more secure because it does not advertise over the network. AND Static routing uses fewer router resources than dynamic routing.

Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?

TO BE USED AS A BACKUP ROUTE

What would be the first step in calculating a summarized route for 5 networks?

Write all network numbers in binary.

What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.)

he interface ID exit interface AND the IP address of the next-hop neighbor

Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?

ip route 0.0.0.0 0.0.0.0 s0/0/0 ip route 0.0.0.0 0.0.0.0 s0/1/0 10

What is the correct syntax of a floating static route?

ip route 209.165.200.228 255.255.255.248 10.0.0.1 120

Refer to the exhibit. What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::2

What does VLSM allow a network administrator to do?

utilize multiple different subnet masks in the same IP address space