Lesson 12: Radar and ATC services ; Airspace Review

124. Which of the following codes should be set for VFR flight in Class E airspace? A. 1200, Mode A/3. B. 1200, Mode F. C. 4600, Mode S.

A

An operable 4096-code transponder and Mode C encoding altimeter are required in A. Class B airspace and within 30 miles of the Class B primary airport. B. Class D airspace. C. Class E airspace below 10,000 feet MSL).

A

An operable 4096-code transponder with an encoding altimeter is required in which airspace? A Class A, Class B (and within 30 miles of the Class B primary airport), and Class C. B. Class D and Class E (below 10,000 feet MSL). C. Class D and Class G (below 10,000 feet MSL).

A

At an altitude below 18,000 feet MSL, which transponder code should be selected? A. Mode A/3, Code 1200. B. Mode F, Code 1200. C. Mode C, Code 4096.

A

The correct method of stating 4,500 feet MSL to ATC is A. "FOUR THOUSAND FIVE HUNDRED." B. "FOUR POINT FIVE." C. "FORTY-FIVE HUNDRED FEET MSL."

A

Unless otherwise authorized, if flying a transponder equipped aircraft, a pilot should 0s squawk which VFR code? A. 1200 B. 7600 C. 7700

A

When flying HAWK N666CB, the proper phraseology for initial contact with McAlester FSS is A. "MC ALESTER RADIO, HAWK SIX SIX SIX CHARLIE BRAVO, RECEIVING ARDMORE VORTAC, OVER." B. "MC ALESTER STATION, HAWK SIX SIX SIX CEE BEE, RECEIVING ARDMORE VORTAC, OVER." C. "MC ALESTER FLIGHT SERVICE STATION, HAWK NOVEMBER SIX CHARLIE BRAVO, RECEIVING ARDMORE VORTAC, OVER."

A

When operating under VFR below 18,000 feet MSL, unless otherwise authorized, what transponder code should be selected? A. 1200 В. 7600 С. 7700

A

If Air Traffic Control advises that radar service is terminated when the pilot is departing Class C airspace, the transponder should be set to code A. 0000 В. 1200 С. 4096

B

When making routine transponder code changes, pilots should avoid inadvertent selection of which code? A. 1200 В. 7600 C. 4096

B

Maintenance records show the last transponder inspection was performed on September 1, 2014. The next inspection will be due no later than A. September 30, 2015. B. September 1, 2016. C. September 30, 2016. 150

C

No person may use an ATC transponder unless it has been tested and inspected within at least the preceding A. 6 calendar months. B. 12 calendar months. С. 24 calendar months.

C

The correct method of stating 10,500 feet MSL to ATC is A. "TEN THOUSAND, FIVE HUNDRED FFET" B. "TEN POINT FIVE." C. "ONE ZERO THOUSAND, FIVE HUNDRED"

C

When making routine transponder code changes, pilots should avoid inadvertent selection of which codes? A. 7200 В. 7000 С. 7500

C

Your transponder is inoperative. In order to enter Class B airspace, you must submit a request for a deviation from the A. ATC facility no less than 24 hr. before the proposed operation. B. nearest FSDO 24 hr. before the proposed operation. C. controlling ATC facility at least 1 hr. before the proposed flight.

C