181-190

अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!

A

A customer's workstation will not boot A technician runs diagnostics on the system and discovers it is set up in a RAID 0 configuration, and a single SATA hard drive failed. The system was set up for Performance. Once repaired the customer request redundancy be built into the system and an increase in performance. Which of the following describes how the technician should set up the new RAID configuration? A. RAID 1 configuration that will utilize new SSD. B. RAID 2 configuration that will allow the loss of a hard drive without failure. C. RAID 6 configuration that will allow the loss of two hard drives without failure. D. RAID 10 configuration utilizing HDD

D

A network administrator is troubleshooting a notebook that is not loading the local Windows 10 operating system. All the computers inside the company are installed using UEFI mode selected. The message on the screen shows a failed attempt to connect to a PXE server. When requested, the end user reported trying to improve the computer's speed by changing some BIOS configurations randomly. Which of the following should the network administrator check FIRST inside BIOS? A. C-states should be configured to 2 B. Secure Boot should be enabled C. Wake-on-LAN should be unchecked D. The PXE server address should be set

B

A technician is replacing an older video card with a new high-end video card in a workstation. The installation was successful, the new card seated properly, and power is connected. However, upon booting, the computer now emits several beeps and will not boot, but shows no error messages. Which of the following is MOST likely the cause of this issue? A. The BIOS is out-of-date B. The is not enough PSU output C. There is an onboard RAM mismatch D. GPU is overlocked E. The firmware is out-of-date

B

A technician wants to block remote logins to a server. Which of the following ports should be blocked? A. 21 B. 23 C. 80 D. 443

C

A user has reported application connectivity problems to the network administrator. The network administrator knows there have been firewall configuration changes recently by a security vendor and believes the issue could be related to a port being closed on the firewall. Which of the following should the network administrator do NEXT? A. See if the same application fails on another workstation B. Go into the firewall and open the port C. Verify system functionality on the user's workstation D. Document the issue for future reference

A

A workstation was just moved to a new work location without a surge protector. It was working the day before, but now the PC will not power on, the fans will not spin, and there are no signs of activity. Which of the following should the technician do FIRST? A. Check the power cable connection B. Check the voltage of the PSU with a tester C. Test for distended capacitors D. Check the voltage switch

A

Ann, a user, reports that after setting up a new WAP in her kitchen she is experiencing intermittent connectivity issues. Which of the following should a technician check FIRST? A. Channels B. Frequency C. Antenna power level D. SSID

C

Company management wants to be able to give users the ability to work remotely during periods of bad weather. Which of the following should be enabled to allow the workforce to do this? A. NAT B. VLAN C. VPN D. HIPS

A

The cloud model that represents a company maintaining some data in on-premise storage and some data in cloud-based storage is known as: A) hybrid B) private C) public D) community

A

Which of the following devices can utilize VLANs to secure networks? A. Switch B. Hub C. Repeater D. Bridge


संबंधित स्टडी सेट्स

Chapter 9. Flexible Budgets and Performance Analysis

View Set

Lehnes Ch 86: Bacteriostatic Inhibitors of Protein Synthesis: Tetracyclines, Macrolides, and Others

View Set

Programming Logic and Design: Chapter 1 Review Questions

View Set