ch 8 tel 203

what are the cell coverage boundary?

-70 decibel milliwatts (dbm)

When possible, what should you use to conduct an active survey (Choose two)?

-The same equipment as selected for the deployment -the same applications that are to be used in the WLAN

what is the maximum simultaneous?

10

Which piece of information would be of the least use when conducting an indoor site survey? top map

A Topographic Map

significant changes in personnel

Adding several new employees to an office or moving employees from one area to another area may necessitate a new survey site. scip

What is postdeployment site surveys?

After the WLAN is installed, it is important to thoroughly test the setup to ensure that all of the APs are providing the necessary coverage. podss

questionaires

Although paper or electronic questionnaires are often used, in reality these can have a limited value.

shadowing

Although the most time-consuming for both interviewer and the interviewee, following the interviewee around while he performs his normal duties gives the interviewer opportunities to ask questions and receive answers as actual practices occur. shadow

When conducting an indoor site survey, which documents would be of use? blueprints

Blueprints Previous Surveys Network Topology Map Correct Response All of the Above

continuous link test

Checking this box will cause the Active Mode test to run repeadtedly until the stop button on the site survey page is clicked. clt

When conducting a site survey for 5 GHz, what should be documented (Choose Two)?

Cordless Phone Use Radar Use

Of the following, which would not be of use when conducting an indoor site survey? (Choose two)

GPS Inclinometer

What is active manual site survey?

It can provide more insight into the network connectivity and its performance. amss

When towers are to be used in an outdoor WLAN deployment what information should be gathered (Choose Two)?

Local Ordinances Planned Tower Height

what are the 3 major considerations in vowifi?

Packet loss delay jitter

When conducting an outdoor survey for a long distance point-to-point bridge, what should be documented?

Prevailing Winds Interference sources near endpoints Clear Channels Correct Response All of the Above

Which of the following shows energy as a function of frequency at the time the signal is being transmitted? rt vie

Realtime View

Physical changes to a building

Remodeling can introduce new sources of interference within the coverage area of the AP, such as motors or metal structures. pctab

data retries

The data retries sets the number of times a transmission will be repeated if an acknowledgment frame is not returned by the destination device.

destination mac address

The default is the mac address of the AP with which the client adapter is currently associated. dma

delay between packets

The delay in milliseconds between successive transmissions is set here. dbp

Documentation tools

The purpose of these tools is to create documentation of the site survey results so they will be available for future reference. these forms are followed: purpose of the report, survey methods, RF coverage details, throughput findings, and sources of interference. docum tools

group interviews

The same goal as a one-on-one interview yet has the added benefit of several of the participants discussing and exchanging ideas between each other, as well being able to provide multiple dimensions of the same answer. gro int

waterfall view

The waterfall view is a time-based graph that shows the aggregate energy collected since the start of session over time for each frequency.

Which is true about spectrum analyzers? pas rec

They are passive receivers

What is periodic Site Surveys?

This "health check" site survey is generally not as thorough as a postdeployment survey. Instead, the purpose is simply to check that the WLAN is functioning as expected from the perspective of a client device. pss

Why is it important conducting a site survey?

This because a variety of factors can change the performance of the wireless network, and these factors may not have been in existence or may have significantly changed since the original survey.

percent success threshold

This parameter allows the user to establish a basline for what is considered satisfactory performance. pst

Data rate

This parameter sets the bit rate at which packets will be transmitted. dr

packet tx type

This parameter sets the packet type that will be used during the test.

packet size

This parameter sets the size of the packets that will be sent during the test. ps

number of packets

This sets the quantity of packets that will be sent during the test. nop

waveform view

This view shows the aggregate energy collected since the start of a session, with the power of the energy in dbm shown across the frequency range.

Common building materials, such as drywall and glass, will impede RF propagation to some degree. t1

True1

A facilities escort may be required when conducting a site survey. t2

True2

Delay

Unlike packet loss, in which a packet never reaches its destination. del

what is other consideration of antenna?

VoWiFi handset

When conducting manual site surveys, which of the following may be of use to the survey team (choose three)?

Walkie Talkies Digital Cameras Measuring wheels

What is troubleshooting site surveys?

When the WLAN is not functioning as anticipated a troubleshooting site survey can help to identify the reason for the inadequate performance. tss

Which of the following is NOT a part of defining the physical and security requirements of a site?wronthenet

Which applications run on the network

facilitated sessions

a much larger group consisting of all primary and secondary stakeholders are gathered together with the goal of remaining together until all the requirements are gathered. fac sess

sniffer

a technically a trademark name of the sniffer network analyzer product. sniffer

Which type of coverage analysis would you be conducting if you required a WLAN client adaptor to be connected to an AP? act

active

Which is true about planning for a VoWiFI network? 6-10db

adjacent cells should overlap by 6-10 dB

Which site survey analyzer setting sets the number of times a transmission will be repeated if an acknowledgment (ACK) frame is not returned by the destination device? dat ret

data retries

specialized tools

dedicated site survey applications, specturm analyzers, protocol analyzers, and documention tools. spe too

Which of the following is NOT a goal in conducting a site survey? dtcoftheAP

determine the cost of the APs

Which is NOT a part of gathering data for a site survey? existwirelessnic

determining manufacturer of existing wireless nics

Documenting existing network characteristics

document the existing wireless and wired networks. how does the current network support the organization mission what applications run on the network how many users does it support what are the strengths and weaknesses of the current network what is the anticipated growth in network technology?

outdoor surveys

follow the same basic steps listed for a WLAN indoor site survey, with some additional considerations. out sur

what are three steps in conducting a survey?

gathering the background data, data for a site survey involves examining business, and gathering site-specific documentation. 3step

what are the type of data for outside survey site?

height of buildings, location and sizes, type of applications, available of power and data.

changes in network needs

if employees are performing significantly different duties, such as downloading large files on a regular basis, then a new site survey should be performed. chinn

what are 2 ways to gather site-specific documentations? Inspect

inspecting the site blueprints, facility drawings, and other documents.

what documentation tool can be used?

it can be used to record the site survey results so they will be available for future reference. docum tool

what is methodology?

it how outlined survey were conducted. meth

explain physical and security requirements

it is critical to understand current security policies and procedures that are already in force. exp phy and sec req

what is gathering data?

it is for a site survey involves examining business requirements, defining physical and security requirements. gater dat

the rapid growth of network

it is not uncommon for servers and clients to be added to the network to meet an immediate need without properly documenting the changes. the r g ofnet

what does site survey provided?

it provides a realistic understanding of the infrastructure required for the installation of a new wireless network.

packet loss

lost packets can be accommodated in data transmission by requesting that a packet be resent. pack loss

When a user has the requirement to stay connected 100% of the time as they move throughout the WLAN coverage area, they are concerned about __________. mob

mobility

One-on-one interviews

most common interview technique.

what are challenges for setting up a WLAN?

obstatcles such as walls, floors, elevator shafts, and even people can impact the RF signal.

spectrum analayzers

passive receivers.

A survey conducted using software only without visiting the site is referred to as being __________. pred

predictive

Which of the following is true about predeployment site surveys?

prior to installing one or more APs, a predeployment survey should be conducted. The purpose of this survey is to understand the RF signal behavior in the specific environment. press

network traffic characterization

protocol analyzers can be used to paint a picture of the types and makeup of network. net traf chara

network troubleshooting

protocol analyzers can detect and diagnose network problems such as addressing errors and protocol configuration mistakes. net troubleshoot

what are 2 business requirements?

the amount of bandwidth wireless network is being expanded

realtime view

the realtime view displays a traditional spectrum analyzer function in which energy is shown real time as a function of frequency. realtime v

A lift or ladder may be required for an indoor site survey. t3

true3

Aesthetics are often consideration in WLAN site surveys. t4

true4

A previous site survey can be of use in future site survey work. t5

true5

what is passive manual site survey?

used to gather information regarding the RF characteristics on the premises by collecting RF measurements, such as signal strengths, noise levels, and the signal-to-noise ratio. pmss

changes to an existing wireless network

when modifying or extending an existing network structure, it is important to reevaluate the placement of the APs and antennas. ctanewn