Chapter 106

अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!

Two technicians are discussing ABS wheel speed sensors. Technician A says that some ABS use a sensor located in the rear-axle pinion gear area. Technician B says that all ABS use a wheel speed sensor at each wheel. Which technician is correct?

Tech A only

A customer wanted the ABS checked because of tire chirp noise during hard braking. Technician A says that the speed sensors may be defective. Technician B says that tire chirp is normal during an ABS stop on dry pavement. Which technician is correct?

Tech B only

Technician A says that ABS-equipped vehicles can stop quickly and without skidding on all road surfaces even if covered with ice. Technician B says that steering is possible during an ABS stop. Which technician is correct?

Tech B only

The faster a wheel rotates, the higher the frequency produced by a wheel speed sensor.

True

the modulator valve body is part of the master cylinder assembly in _________________ antilock systems

integral

wheel speed sensors consists of a _______________ and a toothed sensor ring also called a _____________.

magnetic pickup, tone ring

the accumulator on ABS systems has a pressure storage chamber filled with ____________

nitrogen gas

a ________________ consists of a wire coil with a movable core and a return spring

solenoid

integral systems do not have a __________________

vacuum booster

on dry or wet pavement the maximum braking traction occurs when tire slip is held between ________ and ________

15%, 30%

a fully charged accumulator in an integral ABS system can store up to ____________ of pressure for power assist braking

2,700 PSI

a tire slips how much during a ABS stop

20%

on snow or ice covered pavement the optimum slip range is __________

20% to 50%

at what speed does the antilock braking system stop controlling the wheel brakes?

5 MPH

Technician A says that ABS may not result in shorter stopping distances compared to brakes without ABS. Technician B says that a pulsating brake pedal during severe braking is a characteristic of most ABS-equipped vehicles. Which technician is correct?

Both

Technician A says that ABS brakes are designed to allow the front wheel to be steered during heavy braking. Technician B says that the ABS dash warning lamp is amber. Which technician is correct?

Both Technicians A and B

Technician A says that some wheel speed sensors are enclosed in a wheel bearing assembly. Technician B says that some wheel speed sensors are exposed to possible damage from road debris. Which technician is correct?

Both Technicians A and B

Technician A says that most ABS units are the integral type. Technician B says that the ABS is disabled (does not function) below about 5 mph (8 km/h). Which technician is correct?

Both technicians A and B

Which type of antilock braking system (ABS) requires the use of four wheel speed sensors?

Four channel

The maximum traction between a tire and the road occurs when the tire is _______________.

Slipping 10 to 20 percent

fluid is usually routed into a spring loaded or pressurized storage reservoir called an _______________

accumulator

nonintegral systems are also known as

add on systems and are the most popular because of their low cost and simplicity


संबंधित स्टडी सेट्स

Reference Angles, Coterminal angles, Standard Position, Coterminal and Reference Angles

View Set

Module 9: Monitoring for Health Problems

View Set

Bsn 395 compass Hesi mid study plan A————NU373 Week 3 EAQ Evolve Elsevier: Oxygenation (Asthma, COPD, RSV)

View Set

Honors persuassion exam 1 psy 4390

View Set

Their eyes were watching God 8-12 quiz

View Set