Chapter 7
What is the main type of weathering in deserts?
physical weathering
What force causes most of the erosion in desert areas?
running water
What is the moraine called that marks the farthest advance of a glacier?
terminal end moraine
How does wind transport sand grains?
by saltation as part of the bed load
Icebergs are produced when large pieces of ice break off from the front of a glacier during a process called
calving
Abrasion changes the desert surface by
cutting and polishing exposed rock surfaces
Desert pavement is created as a result of
deflation
In desert areas, what process results in the formation of a desert pavement?
deflation
The weathered debris in deserts consists mainly of
unchanged rock and mineral fragments
Which of the following is true about ice sheets?
They flow in all directions.
Currently, about what percent of Earth's land surface is covered by glaciers?
10%
During the most recent ice age, what percentage of Earth's surface was covered by glaciers?
30%
Sand dunes that form scalloped rows of sand at right angles to the wind are called
barchanoid dunes
Which of the following is NOT true about glaciers?
They exist only in the Northern Hemisphere
Why can a heavy rain shower cause a large amount of erosion in a desert area?
There is a lack of vegetation to hold the soil in place.
Which of the following statements is NOT true about weathering in deserts?
There is no chemical weathering in deserts.
What is a blowout?
a shallow depression caused by deflation
A cone of debris deposited by running water at the mouth of a canyon in an arid area is known as a(n)
alluvial fan
he rust-colored tint of some desert landscapes is the result of
chemical weathering
A bowl-shaped depression at the head of a glacial valley is a(n)
cirque
In Figure 7-2, which diagram illustrates barchan dunes?
diagram A
In Figure 7-2, which diagram illustrates the dune types that would form if the prevailing winds were steady, sand supply was plentiful, and vegetation was sparse?
diagram B
In Figure 7-2, which diagram illustrates longitudinal dunes?
diagram D
What features are labeled A in Figure 7-1?
drumlins
What feature is labeled B in Figure 7-1?
end moraine
What features, illustrated in Figure 7-1, were deposited by streams flowing in tunnels beneath the ice?
eskers
Which one of the following is NOT an effect that Pleistocene glaciers had on the landscape?
extinction of the dinosaurs
What is the term for all sediments of glacial origin?
glacial drift
A thick ice mass that forms over the land from the accumulation, compaction, and recrystallization of snow is a
glacier
The thick loess deposits in South Dakota, Nebraska, and Iowa
had their source as glacial sediments
The Antarctic Ice Sheet in the Southern Hemisphere
holds almost two-thirds of Earth's fresh water
Where do glaciers form?
in areas where more snow falls than melts
Over time, sand dunes tend to migrate
in the same direction as the wind blows
When wind creates a sand dune, the sheltered side of the dune
is steeper than the windward side
What features are labeled F in Figure 7-1?
kettle lakes
Windblown silt that blankets a landscape is called
loess
Long sand ridges that are oriented more or less parallel to the prevailing wind are called
longitudinal dunes
Deflation affected the Dust Bowl in the 1930s by
lowering the land
In the desert environment, the chemical weathering of rocks is generally reduced because
moisture is lacking and organic acids are scarce
If the steep face of a sand dune is on the southeast side of the dune, then the prevailing wind in this area is from the
northwest
What feature is labeled G in Figure 7-1?
outwash plain
Dunes whose tips point into the wind are called
parabolic dunes
Dry, flat lake beds located in the center of basins in arid areas are called
playas
The loosening and lifting of blocks of rock by glaciers is called
plucking
In the desert, ephemeral streams
run only after it rains
Which of the following features was formed by glacial erosion?
the Great Lakes
One characteristic of glacial movement is that
the movement depends on the balance between accumulation and wastage
Material deposited directly by a glacier is called
till
Which of the following is NOT deposited by wind?
till
The action of abrasion can best be described as
windblown sand cutting and polishing exposed rock surfaces
What is the zone above the snowline on a glacier called?
zone of accumulation