Configuring & Verifying NAT

What are the advantages of using Dynamic NAT over Static NAT?

- Multiple devices on the internal private IPs can share public IPs - Manually configuring NAT routes are not required

You are changing a router from using Static NAT to Dynamic NAT. What command should you run to clear the Static NAT table after deactivating the Static Nat with the command "no ip nat inside source static 172.16.0.10 173.14.0.12"?

clear ip nat translation *

What command shows the list of configured static IP network address translations?

do show ip nat trans

What command creates a static network address translation entry between 10.0.0.10/24 and the outside IP Address 172.15.0.15/24? The inside address is 10.0.0.1/24 and the outside address is 172.13.0.1/24.

ip nat inside source static 10.0.0.10 172.13.0.1

Match the Network Address Translation descriptions to their translation type. Some Options match multiple targets. - NAT - Dynamic NAT - Static NAT - PAT - NAT Overload

- NAT - It takes internal addresses and uses ports to share a public address - Dynamic NAT - Can translate from multiple internal addresses to a public address - Static NAT - Provides a direct one-to-one translation from internal to a public address - PAT - Can translate from multiple internal addresses to a public address. & It takes internal addresses and uses ports to share a public address - NAT overload - Can translate from multiple internal addresses to a public address. & It takes internal addresses and uses ports to share a public address

You want to create a static address translation between Host C on your internal network and address 172.35.116.1, which has been assigned by your ISP. Which commands would you need to enter to enable this? (Choose three.)

- Router(config)#ip nat inside source static 10.1.1.4 172.35.116.1 - Router(config-if)#ip nat inside - Router(config-if)#ip nat outside

Your router has been configured with Dynamic NAT and has 6 assigned Public IP Addresses from your ISP. How many connections can be made by devices before one device has to wait for a connection to become free?

6

You have entered the following command after setting up your Dynamic NAT and Access Lists but get a syntax error. What is missing from the command "ip nat pool MYEDGE 172.14.0.1 172.14.0.3"

A netmask parameter is required

Refer to the command output. ip nat pool net-208 171.69.233.209 171.69.233.222 netmask 255.255.255.240 ip nat inside source list 1 pool net-208 ! interface serial 0 ip address 171.69.232.182 255.255.255.240 ip nat outside ! interface ethernet 0 ip address 192.168.1.94 255.255.255.0 ip nat inside ! access-list 1 permit 192.168.1.0 0.0.0.255 What is being configured?

Dynamic NAT