Navigation
To track inbound on the 215 radial of a VOR station, the recommended procedure is to set the OBS to...
035 and make heading corrections towards the CDI needle
When navigating using only VOR/DME based on RNAV, selection of a VOR NAVAID that does not have DME service will... 1. result in loss of RNAV capacity 2. have no effect on navigationa capacity 3. not impact navigation provided enough of the GPS is operating
1
When checking the course sensitivity of a VOR receiver, how many degrees should the OBS be rotated to move the CDI from the center to the last dot on either side?
10 to 12 degrees
Pressure altitude is 12000 True air temp is +50oF What is density altitude?
14130
The track outbound on the 180 radial of a VOR station, the recommended procedure is to set the OBS to...
180 and make heading corrections toward the CDI needle (there will be a from indicaiton)
An aircraft 60 miles from a VOR station has a CDI indication of 1/5 deflection, this represents a course centerline deviation of...
2 miles
If fuel consumption is 80 pounds per hour and groundspeed is 180 knots, how much fuel is required for an airplane to travel 460 NM?
205 lbs
If an airplane is consuming 95 pounds per hour at cruising altitude of 6,500 feet and the groundspeed is 173 knots, how much fuel is required to travel 450 NM?
248 pounds
When must an operational check on the aircraft VOR equipment be accomplished to operate under IFR? Within the preceding...
30 days
When using VOT to make a VOR receiver check, the CDI should be centered and the OBS should indicate that the aircraft is on the...
360 radial
What is the maximum bearing error allowed for an operational VOR equipment check when using an FAA approved ground test signal?
4 degrees
For IFR operations off established airways, ROUTE OF FLIGHT portion of an IFR flight plan should list VOR naviagational aids which are no more than _______ miles apart.
80
Which situation would result in reverse sensing of a VOR receiver? A. flying a heading that is reciprocal of the bearing selected on the OBS B. setting the OBS to a bearing that is 90 degrees from the bearing on which the aircraft is located C. Failing ot change the OBS from the selected inbound course to the outbound course after passing that station
A
What procedure could a pilot use to navigate under VFR from one point to another when ground references are not visible?
Dead reckoning
Which data must be recorded in the aircraft logbook or other record by a pilot making a VOR operational check for IFR operations?
Name (signature), Location, Date, bearing error.
How should the pilot make a VOR receiver check when the aircraft is located on the designated checkpoint on the airport surface?
Set the OBS to the designated radial, the CDI must center within plus or minus 4 degrees of that radial with a from indication.
True course measurements on a Sectional Aeronautical chart should be made at the meridian near the midpoint of the course becasue the...
angles formed by lines of longitude and the course line vary from point to point
As air temperature increases, density altitude will...
increase
When the CDI needle is centered during an airborne VOR check, the omnibearing selector and the To/From indicator should read...
within 6 degrees of the selected radial
