1PH Motors And Auxiliary Controls Final Test

Lakukan tugas rumah & ujian kamu dengan baik sekarang menggunakan Quizwiz!

How many windings does the stator of a shaded-pole motor have?

1

an electronically commutated motor(ecm), also known as a variable speed motor operates at lower amps of the same size PSC motor. Approximately how much lower?

1/3

The microfarad rating of a replacement capacitor must be within +/- _____________ % of the original capacitor

10

starting components are designed to remove the start winding or start capacitor from the motor circuit when the motor reaches ________% of speed

75

AC motors typically come with ______________ poles

All of the above (2,4,6,8)

What type of bearings may a motor have?

All of the above (ball, roller, sleeve)

What are the ends of the motor referred to as?

All of the above (end plates, end bells, end shields)

Standard types of motor enclosures on AC motors include:

All of the above (open, totally enclosed, explosion proof)

What can cause cycling on the overload?

All of the above(excessive amp draw, excessive motor heat, excessive compressor heat)

What is a big enemy of AC motors?

All of the above(moisture, heat, over-lubrication)

After installing a new motor, the technician should always check the motor's ____________

Amp draw

Which of the motors below has the best starting torque?

Capacitor start

This electrical diagram is an example of a ___________

Capacitor start motor

A belt-driven air handler using a split-phase motor will usually be equipped with a _________ to remove the start winding on motor start-up

Centrifugal Switch

Which of the motors below is the most efficient?

ECM

AC motors provide superior torque and speed control over DC motors.

False

Because of the heat-activated varnish insulation on motor windings, over lubrication of electric motors is not a problem

False

In AC motors, a two pole AC motor runs slower than a four pole AC motor

False

Shaded-pole motors have both a run and start winding.

False

Supply voltage for a motor must be within +/- 20% of a nameplate voltage

False

The more poles a motor has the lower its torque will be.

False

The most common AC motors have three or seven poles in the stator

False

The two sets of windings found in the stater of an AC motor are called the run and walk windings

False

an electrical motor accepts mechanical energy as rotation and torque and converts it into electrical energy as voltage and current

False

over lubrication of motors:

Is deadly to electric motors

When an AC motor is first energized, it will immediately draw _________ amps

Locked-Rotor

what is meant by the term "impedence protected" on the nameplate of a motor

Motor will not draw excessive current when overloaded or stalled.

The contacts on a potential relay with no power applied would _________

Normally closed

The contacts on a current relay with no power applied would _________

Normally open

This electrical diagram is an example of a ___________

PSC

Which of the motors below must be equipped with a run capacitor?

PSC

which of the motors below is available in multi speed applications of up to six speeds

PSC

All motors must produce _________

Rotation

What type of capacitor, usually has a metal case and is designed to always be in the motor circuit

Run

Capacitors are always connected in ________ with the start winding

Series

Which of the motors below requires no centrifugal switch or start relay?

Shaded Pole

which of the motors below does not have a start winding

Shaded Pole

what are the motors below can be considered to be "impedance protected"

Shaded pole

This electrical diagram is an example of a ___________

Shaded pole motor

since most motors produce torque, the motor shaft will typically run 3% slower than the stator synchronous speed. What do you call this speed difference?

Slip

An eight pole motor will run ______ than a two pole motor

Slower

Which of the motors below can be used in belt applications?

Split phase

This electrical diagram is an example of a ___________

Split phase motor

In some AC motors; the second winding on the stator, known as the ___________ winding, is rated for intermittent duty only.

Start

On a PSC motor, whenever you replace the motor you should also replace what part?

The capacitor

What is the stationary part of the AC motor is called?

The stator

All AC motors should be equipped with _______ delay fuses or circuit breakers

Time

The induction principle with AC motors is similar to what other part?

Transformers

A motor is considered overloaded if its amp draw is more than 10% over nameplate full load amps (FLA)

True

A two speed motor will usually have more windings than a one speed motor

True

AC motors are simpler and construction than DC motors

True

Heat-activated varnish applied to stator coils help exclude moisture and contaminants and act as motor winding insulation

True

Magnetic opposition and attraction produced between the stator and rotor usually results in rotation of the motor shaft

True

Most AC motors run at nearly a constant speed that is set by the number of poles and the supply frequency

True

On most small fractional horsepower motors, the end bells are secured by a set of bolts that extend through the motor from end to end

True

The poles of the start winding, on a AC stator, are typically centered halfway between the poles of the first windings

True

The rotating part of all AC motors is referred to as the rotor

True

The type of electric motors used in the residential HVAC industry are typically fractional horsepower motors

True

When replacing a fractional horsepower motor, its frame size is determined by measuring the motor's diameter.

True

if a motor used for air handling is not installed in the airflow, it must be equipped within an internal, shaft mounted fan for proper cooling

True

in some AC stators, the start winding is easily identifiable because it is wound with a lighter gauge of wire than the first winding

True

it is acceptable to replace a 5 uF capacitor rated at 370 VAC with a 5 uF capacitor rated at 440 VAC

True

squirrel-cage rotors are the most widely used rotor types in AC motors

True


Set pelajaran terkait

ELA test 3/8/18, Key Terms for Argumentative Essay

View Set

Job 25 - Flashcard MC Questions - Ted Hildebrandt

View Set

Exam 3: Ch. 9 to end of the semester.

View Set

APES Community Interactions - Study Guide

View Set

Walt Disney feature animation part 2 (quiz 11)

View Set

PEH - 6 Different Basic Swimming Styles and Strokes

View Set

Week 3- HEALTH ASSESSMENT LECTURE + LAB

View Set