CCNA2 Missed Qs
Refer to the exhibit. A Layer 3 switch routes for three VLANs and connects to a router for Internet connectivity. Which two configurations would be applied to the switch? (Choose two.)
(config)# ip routing
Refer to the exhibit. Assuming that the routing tables are up to date and no ARP messages are needed, after a packet leaves H1, how many times is the L2 header rewritten in the path to H2?
2
Which subnet mask would be used as the classful mask for the IP address 128.107.52.27?
255.255.0.0
Refer to the exhibit. If RIPng is enabled, how many hops away does R1 consider the 2001:0DB8:ACAD:1::/64 network to be?
3
Refer to the exhibit. A small business uses VLANs 8, 20, 25, and 30 on two switches that have a trunk link between them. What native VLAN should be used on the trunk if Cisco best practices are being implemented?
5
Refer to the exhibit. A network administrator has just configured address translation and is verifying the configuration. What three things can the administrator verify? (Choose three.)
Address translation is working. A standard access list numbered 1 was used as part of the configuration process. Two types of NAT are enabled.
Match the switching characteristic to the correct term. (Not all options are used.)
This is the ability to store frames before forwarding them: Buffering Each switch port can simultaneously send and receive data: Full duplex Each switch port creater this by reducing the possibility of collisions: Collsion Domain Switches use this to forward frames to the destination: Mac address table
The acronym describes the type of traffic that has strict QoS requirements and utilizes a one-way overall delay less than 150 ms across the network
VoIP
Which network design may be recommended for a small campus site that consists of a single building with a few users?
a collapsed core network design
A standard ACL has been configured on a router to allow only clients from the 10.11.110.0/24 network to telnet or to ssh to the VTY lines of the router. Which command will correctly apply this ACL?
access-group 11 in
The computers used by the network administrators for a school are on the 10.7.0.0/27 network. Which two commands are needed at a minimum to apply an ACL that will ensure that only devices that are used by the network administrators will be allowed Telnet access to the routers? (Choose two.)
access-list 5 permit 10.7.0.0 0.0.0.31 access-class 5 in
A router learns of multiple routes toward the same destination. Which value in a routing table represents the trustworthiness of learned routes and is used by the router to determine which route to install into the routing table for this specific situation?
administrative distance
Which value in a routing table represents trustworthiness and is used by the router to determine which route to install into the routing table when there are multiple routes toward the same destination?
administrative distance
Which value represents the "trustworthiness" of a route and is used to determine which route to install into the routing table when there are multiple routes toward the same destination?
administrative distance
A new network policy requires an ACL to deny HTTP access from all guests to a web server at the main office. All guests use addressing from the IPv6 subnet 2001:DB8:19:C::/64. The web server is configured with the address 2001:DB8:19:A::105/64. Implementing the NoWeb ACL on the interface for the guest LAN requires which three commands? (Choose two.)
deny tcp any host 2001:DB8:19:A::105 eq 80 permit ipv6 any any
A security specialist designs an ACL to deny access to a web server from all sales staff. The sales staff are assigned addressing from the IPv6 subnet 2001:db8:48:2c::/64. The web server is assigned the address 2001:db8:48:1c::50/64. Configuring the WebFilter ACL on the LAN interface for the sales staff will require which three commands? (Choose three.)
deny tcp host 2001:db8:48:1c::50 any eq 80 deny tcp any host 2001:db8:48:1c::50 eq 80 deny ipv6 any any
A small-sized company has 20 workstations and 2 servers. The company has been assigned a group of IPv4 addresses 209.165.200.224/29 from its ISP. What technology should the company implement in order to allow the workstations to access the services over the Internet?
dynamic NAT
Match the router memory type that provides the primary storage for the router feature. (Not all options are used.)
full operating system flash limited operating system ROM routing table RAM startup configuration file NVRAM
The OSPF Type 1 packet is the (hello) packet.
hello
Which two statements are characteristics of routed ports on a multilayer switch? (Choose two.)
In a switched network, they are mostly configured between switches at the core and distribution layers They are not associated with a particular VLAN
A network administrator is explaining to a junior colleague the use of the lt and gt keywords when filtering packets using an extended ACL. Where would the lt or gt keywords be used
in an IPv4 extended ACL that allows packets from a range of TCP ports destined for a specific network device
Static routes are configured by the use of the (ip route, IP ROUTE) global configuration command.
ip route
Static routes are configured by the use of the global configuration command. ANS: (ip route)
ip route
What are two features of a link-state routing protocol? (Choose two.)
Routers send triggered updates in response to a change. Routers create a topology of the network by using information from other routers.
Which command will enable auto-MDIX on a device?
S1(config-if)# mdix auto
Which two commands should be implemented to return a Cisco 3560 trunk port to its default configuration? (Choose two.)
S1(config-if)# no switchport trunk allowed vlan S1(config-if)# no switchport trunk native vlan
Refer to the exhibit. An attacker on PC X sends a frame with two 802.1Q tags on it, one for VLAN 40 and another for VLAN 12. What will happen to this frame?
SW-A will remove both tags and forward the rest of the frame across the trunk link, where SW-B will forward the frame to hosts on VLAN 40.
What is the effect of issuing the passive-interface default command on a router that is configured for OSPF?
It prevents OSPF messages from being sent out any OSPF-enabled interface.
What caused the following error message to appear? 01:11:12: %PM-4-ERR_DISABLE: psecure-violation error detected on Fa0/8, putting Fa0/8 in err-disable state 01:11:12: %PORT_SECURITY-2-PSECURE_VIOLATION: Security violation occurred, caused by MAC address 0011.a0d4.12a0 on port FastEthernet0/8. 01:11:13: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/8, changed state to down 01:11:14: %LINK-3-UPDOWN: Interface FastEthernet0/8, changed state to down
Port security was enabled on the switch port, and an unauthorized connection was made on switch port Fa0/8.
What is the purpose of an access list that is created as part of configuring IP address translation?
The access list defines the private IP addresses that are to be translated.
While analyzing log files, a network administrator notices reoccurring native VLAN mismatches. What is the effect of these reoccurring errors?
The control and management traffic on the error-occurring trunk port is being misdirected or dropped.
Which three requirements are necessary for two OSPFv2 routers to form an adjacency? (Choose three.)
The link interface subnet masks must match. The two routers must include the inter-router link network in an OSPFv2 network command. The OSPF hello or dead timers on each router must match
Which two characteristics describe the native VLAN? (Choose two.)
The native VLAN provides a common identifier to both ends of a trunk. The native VLAN traffic will be untagged across the trunk link.
Which three advantages are provided by static routing? (Choose three.)
The path a static route uses to send data is known. Static routing does not advertise over the network, thus providing better security. Static routing typically uses less network bandwidth and fewer CPU operations than dynamic routing does.
Refer to the exhibit. A network administrator is configuring a router as a DHCPv6 server. The administrator issues a show ipv6 dhcp pool command to verify the configuration. Which statement explains the reason that the number of active clients is 0?
The state is not maintained by the DHCPv6 server under stateless DHCPv6 operation.
What happens immediately after two OSPF routers have exchanged hello packets and have formed a neighbor adjacency?
They exchange abbreviated lists of their LSDBs
A router has used the OSPF protocol to learn a route to the 172.16.32.0/19 network. Which command will implement a backup floating static route to this network?
ip route 172.16.32.0 255.255.224.0 S0/0/0 200
Refer to the exhibit. Which type of route is 172.16.0.0/16
level 1 parent route
Refer to the exhibit. An ACL preventing FTP and HTTP access to the interval web server from all teaching assistants has been implemented in the Board Office. The address of the web server is 172.20.1.100 and all teaching assistants are assigned addresses in the 172.21.1.0/24 network. After implement the ACL, access to all servers is denied. What is the problem?
named ACLs requite the use of port numbers
A network technician is configuring port security on switches. The interfaces on the switches are configured in such a way that when a violation occurs, packets with unknown source address are dropped and no notification is sent. Which violation mode is configured on the interfaces?
protect
A network administrator is implementing a distance vector routing protocol between neighbors on the network. In the context of distance vector protocols, what is a neighbor?
routers that share a link and use the same routing protocol
Which three pieces of information does a link-state routing protocol use initially as link-state information for locally connected links? (Choose three.)
the cost of that link the type of network link the link router interface IP address and subnet mask
How is the router ID for an OSPFv3 router determined?
the highest IPv4 address on an active interface
Which information does a switch use to populate the MAC address table?
the source MAC address and the incoming port
What address will summarize the LANs attached to routers 2-A and 3-A and can be configured in a summary static route to advertise them to an upstream neighbor?
10.0.0.0/21
Refer to the exhibit. Which highlighted value represents a specific destination network in the routing table?
10.16.100.128
What is the purpose of setting the native VLAN separate from data VLANs?
A separate VLAN should be used to carry uncommon untagged frames to avoid bandwidth contention on data VLANs.
Refer to the exhibit. How did the router obtain the last route that is shown?
Another router in the same organization provided the default route by using a dynamic routing protocol.
Refer to the exhibit. The Branch Router has an OSPF neighbor relationship with the HQ router over the 198.51.0.4/30 network. The 198.51.0.8/30 network link should serve as a backup when the OSPF link goes down. The floating static route command ip route 0.0.0.0 0.0.0.0 S0/1/1 100 was issued on Branch and now traffic is using the backup link even when the OSPF link is up and functioning. Which change should be made to the static route command so that traffic will only use the OSPF link when it is up?
Change the administrative distance to 120.
What are two ways of turning off DTP on a trunk link between switches? (Choose two.)
Configure attached switch ports with the nonegotiate command option. Place the two attached switch ports in access mode.
Which two methods can be used to provide secure management access to a Cisco switch? (Choose two.)
Configure specific ports for management traffic on a specific VLAN. Configure SSH for remote management.
Which three addresses could be used as the destination address for OSPFv3 messages? (Choose three.
FF02::5 FF02::6 FE80::1
Which two statements are true about half-duplex and full-duplex communications? (Choose two.)
Full duplex offers 100 percent potential use of the bandwidth Full duplex allows both ends to transmit and receive simultaneously
The buffers for packet processing and the running configuration file are temporarily stored in which type of router memory?
RAM
Refer to the exhibit. If the switch reboots and all routers have to re-establish OSPF adjacencies, which routers will become the new DR and BDR?
Router R4 will become the DR and router R3 will become the BDR.
Refer to the exhibit. Host A has sent a packet to host B. What will be the source MAC and IP addresses on the packet when it arrives at host B?
Source MAC: 00E0.FE91.7799 Source IP: 10.1.1.10
A network technician has been asked to secure all switches in the campus network. The security requirements are for each switch to automatically learn and add MAC addresses to both the address table and the running configuration. Which port security configuration will meet these requirements?
sticky secure MAC addresses