DRIVELINES

ON A FRONT WHEEL DRIVE HALFSHAFT, WHAT COMPONENT DOES THE SAME FUNCTION AS A SLIP YOKE?

68 in

WHAT WOULD THE CUSTOMER COMPLAINT BE IF YOU HAD A BROKEN TRANSAXLE OR MOTOR MOUNT?

A shatter or vibration on tale off

WHAT TYPES OF CONCERNS WOULD BE PRESENT IF WE HAD A WORN INBOARD JOINT?

Clunking on acceleration

NAME THE THREE TYPES OF CARDAN JOINTS.

D clip (Data), C clip (Cleveland), Plastic injected (GM)

LIST THE FIVE REQUIREMENTS OF A DRIVELINE:

Flexibility, length change with the Slip yoke, the balance, proper working angles, Fasting

DESCRIBE WHY A DOUBLE CARDAN IS CLASSIFIED AS A CV JOINT?

It keeps the same speed on the input and output

WHAT SHOULD YOU DO BEFORE REMOVING A TWO PIECE DRIVESHART?

Mark it

WHAT PART, IF ANY, DOES HALFSHAFTS AND CV JOINTS PLAY IN THE STEERING SYSTEM?

None

REEPPA

Out board FiX

TRIPOT

Plunge joint

WHAT IS THE REASON FOR INCORPORATING A SLIP YOKE IN A DRIVE SHAFT?

The inner plunging joint (Double off set)

WHAT COMPONENT WOULD USUALLY CAUSE A CLICKING NOISE WHEN TURNING?

The out board rzeppa

WHAT IS THE MOST COMMON OUT BOARD JOINT, AND HOW SHARP CAN IT TURN?

The rzeppa 48 degrees

DEFINE SPEED FLUCTUATION:

Two drive line components turning at different speed

5. WHAT IS THE MAXIMUM PRACTICAL LENGTH OF A ONE PIECE DRIVE SHAFT?

center support bearing or carrier bearing.

DOUBLE OFFSET

in board plunge Joint

CROSS GROOVE

plunge joint

WHICH WAY DOES A ZERK FITTING NEED TO BE FACEING?

towards the drive Shaft