Engine Repair (A1)

Lakukan tugas rumah & ujian kamu dengan baik sekarang menggunakan Quizwiz!

14.All of the following statements about a battery load test are true EXCEPT:

A. The battery should be discharged at one-half the cold cranking rating duringthe test. B. The battery temperature should be above 40°F before performing the test. C. The battery's specific gravity should be above 1,190 before performing the test. D. The battery is satisfactory if the voltage remains above 8.8 V after fifteen secondswith the battery temperature at 70°F. All true except D.

3. During a cylinder power balance test on a four-cylinder port fuel-injected engine, one cylinder has a 75-rpm drop and the other cylinders have a 125-rpm drop. Technician A says that the cylinder with a 75-rpm drop may have a burned exhaust valve. Technician B says that the cylinder with a 75-rpm drop may have a bad fuel injector. Who is correct?

Both A and B technicians

6. While diagnosing an engine's timing belt condition, Technician A says that somevehicle manufacturers recommend checking timing belt wear by measuring the installed length of the belt tensioner. Technician B says that on some engines the valves will strike the top of the pistons if the timing belt jump breaks. Who is correct?

Both A and B technicians

10. A cooling system is pressurized to 15 psi with a pressure tester. After five minutes, thepressure reading on the tester is 3 psi, and there are no external leaks. Technician A says that the automatic transmission cooler may be leaking. Technician B says that the head gasket may be leaking. Who is correct?

Both technicians A and B

5. The cause of excessive valve stem height could be: A. an improperly installed valve guide.

Excessive material removed from the valve seat.

11. An engine no-start condition is being diagnosed. A 12-volt test light connected fromthe coil's negative primary terminal to ground flashes while cranking the engine. The most likely cause for the no-start condition is a faulty:

Faulty Ignition Coil

13. An accumulation of oil in the air cleaner may be caused by a:

Partially restricted pvc valve

1. If an engine experiences a sharp, metallic rapping noise only when it is idling, thetrouble could be worn: A. main bearings.

Piston pins

12. Technician A says that an intake manifold vacuum leak may cause cylinder misfiring at idle speed. Technician B says that an intake manifold vacuum leak may cause cylinder misfiring at 2,500 rpm. Who is correct?

Technician A

4. While discussing cylinder head service, Technician A says that torque-to-yield boltsmay be reused if they are not damaged. Technician B says that torque-to-yield bolts are usually tightened to a specified torque and then rotated a certain number of degrees. Who is correct?

Technician B

8. While measuring cylinder taper and out-of-round, Technician A says that the cylinder diameter should be measured at two vertical locations. Technician B says that cylinder out-of-round is the difference between the cylinder diameter in the thrust and axial directions. Who is correct?

Technician B

9. Technician A says that when checking connecting rods, they should be measuredto determine if they are bent. Technician B says that each connecting rod should be measured for a twisted condition. Who is correct?

Technician B

7. While discussing engine sealants, Technician A says that RTV sealer dries in the absence of air. Technician B says that anaerobic sealer dries in the absence of air. Who is correct?

Technician B is correct

2. On a port fuel-injected engine, the cause of excessive black smoke in the exhaustcould be:

high fuel pressure


Set pelajaran terkait

Folders and Files - vocabulary & techniques

View Set

Muscle Excitation and Relaxation

View Set

Principles of Economics - Modules 4-7 Review

View Set

BASIC VEHICLE TECHNOLOGIES 2: ENGINES

View Set

Ch. 9 connect practice questions

View Set

1.5 Indirect Proof and 1.6 Proofs Involving Quantifiers

View Set

Management of Patients with Immunodeficiency Disorders

View Set

chapter 25 intro to the health care

View Set