Osha STRUCK-BY HAZARDS

Lakukan tugas rumah & ujian kamu dengan baik sekarang menggunakan Quizwiz!

Ball and socket connectors are used to attach conductor stringing blocks to insulators on the arms of 90 foot metal towers of electrical transmission lines. Normally stainless steel cotter keys secure the ball and socket connector in place. In this case, however, black electrical tape was wrapped around the socket to keep the ball in place rather than a cotter key. The tape apparently stretched and the ball came loose, dropping the stringing block approximately 90 feet onto the head of an employee below, one of a four-man erection crew. What should be recommended to prevent this accident from happening again?

-Rigging and equipment must be inspected regularly and maintained in safe operating condition as required by general provisions of OSHA's construction. -Employees must be instructed to recognize and avoid unsafe conditions and be made aware of regulations which apply to the work and the work area to eliminate safety and health hazards as required in the safety

A carpenter apprentice was killed when he was struck in the head by a nail that was fired from a powder actuated tool. The tool operator, while attempting to anchor a plywood form in preparation for pouring a concrete wall, fired the gun, causing the nail to pass through the hollow wall. The nail traveled some twenty-seven feet before striking the victim. The tool operator had never received training in the proper use of the tool, and none of the employees in the area were wearing personal protective equipment. What should be recommended to prevent this accident from happening again?

-Train employees using powder-actuated tools in safe operation of the particular tool. -Train employees on operating powder actuated tools to avoid firing into easily penetrated materials. -Institute a program for frequent and regular inspections of job site, materials, and equipment by a competent person(s). -Require employees exposed to the potential hazards associated with flying nails to use appropriate personal protective equipment.

How many categories of struck-by hazards are there?

4

What should you do if you are not operating heavy equipment?

Be sure the operator ca see you stay away from the equipment

Employers should ensure all earth moving/compacting equipment with obstructed view does not operate in reverse gear unless the equipment has a reverse signal alarm or a worker has been designated to signal when it is safe. For which type of safety is this action taken?

Employer-required actions for heavy equipment safety

In addition to safe practices, what can you use to give yourself improved protection from struck-by hazards?

PPE aproiot for the hazard to which you will be exsposed

Four workers were installing signs on a highway when an SUV entered the work area and struck one of the workers. What type of event is this?

Struck by

Inspect tools to ensure that protective guards are removed. Is this a safe or unsafe practice?

Unsafe

Employers should ensure all earth moving/compacting equipment with obstructed view does not operate in reverse gear unless the equipment has a reverse signal alarm or a worker has been designated to signal when it is safe. For which type of safety is this action taken?

employer-requierd action for heavy equipment safty

In which areas does your employer have a responsibility to protect you from struck-by hazards?

motor vehicles, general practice, and heavy equitment

What is the hazard being demonstrated in this image? *pallets held up by a crane

swinging object

Should you fire a nail gun into the air in a safe direction prior to use?

you should never fire the nail gun in to the air


Set pelajaran terkait

ADN5 Chap. 48 Child With an Alteration in Metabolism/Endocrine Disorder

View Set

CompTIA A+ Cert Master 5.4 Hardware and Network Troubleshooting Study

View Set

Perceptron + MLE/MAP + Naive Bayes + Logistic/linear Regression

View Set

Biology Chapter 3B - 2 Cellular transport

View Set

Marketing Principles Chapter 1-5 Exam

View Set

2.4 Cash Flow: Cash Flow from Assets

View Set