Plan Reading Volume 1
How many quarter- quarter sections are in one section?
16
How many acres are there in a township?
23040
How many sections are in a township?
36 sections
Elevation View
A view showing the height of an object. Elevations may be from the front, rear or side views.
The abbreviation B.M. indicates?
Bench Mark
H.000001.6
Construction
Plans
Contract drawings, showing location, type, dimensions, and other details of the prescribed work.
H.000001.5
Design Engineering/ surveying
Permanent and temporary benchmarks give a point of known...
Elevation and Location
H.000001.2
Environmental
Cutting Plane Lines
Indicate the exact point where the engineer wants to show more detail of and object.
Bearing Number
Indicates the direction of a line. (e.g. a centerline, side of a parcel, etc.)
Surveyors record elevation (vertical) information in a ledger called a..
LEVEL BOOK
Title sheets in a plan set reference the surveyors...
LEVEL BOOK
RISE=
Level Length (in feet) x Rate of Slope (in feet)
Township lines go???
North to South
Property can be personal property or real property. Most highway agencies refer to land as real property or...
Parcels
H.000001.3
Right of Way
The abbreviation T.B.M. indicates?
Temporary Bench Mark
Elevation
The height of a permanent object above average sea level.
H.000001.4
Utilities Relocation
Highway Plans Describe:
WHAT to build and WHERE to build.
Standard Specifications
a book of specifications for general application and repetitive use.
Plan Change and/or Special Agreement
a document describing and detailing changes to the contract. It establishes reasons for the changes, specification requirements, method of measurement, basis of payment, etc.
Parcels
a land area needed for construction, or other purposes.
Bench Mark
a permanent point (monument) of known elevation.
Plan View
a view from directly above the object, looking down on the object.
Cross- Section View
a view showing the inside of an object as though a piece of the object has been sliced away.
Special Provisions
additions and revisions to the standard and supplemental specifications covering conditions applicable to the project.
supplemental Specifications
additions and revisions to the standard specifications
Adding "ET AL" to the property owner name indicates?
and others
Adding "ET UX" to a property owner name, indicates?
and wife
Highway Plans are...
drawings and notations for a specific project.
FILL=
earth placed
CUT=
earth removed
H.000001.1
feasibility/ non construction
"L"
is the length of the curve from the P.C. to the P.T.
Station Numbers work.....
just as 12 inches make 1 foot, 100 feet make 1 station.
Township Lines
lines drawn parallel to the North-South Dividing line at six-mile intervals.
Land is a _________ or real property.
parcel
Property lines indicate...
property ownership limits
Specifications
the compilation of provisions and requirements for the performance of prescribed work.
Ratio (Example= 4:1 )
the first number is always the level length, and the next number is the rise.
Length (L)
the length of a curve from the P.C. to the P.T.
Point of Tangency (P.T.)
the point where the curved segment of the highway ends, and a new tangent segment begins.
Point of intersection (P.I)
the point where the extension lines of the tangent segments meet or intersect.
Point of Curvature (P.C.)
the point where the tangent (or straight) segment of the highway begins to curve.
Grade
the slope of a land segment.
T
the tangent distance from the P.C. to the P.I. or the P.I. to the P.T. Both distances are the same.
Vertical Curves Occur In 2 Instances:
when the proposed highway goes over a hilltop (crest) or when it travels down into a valley (sag).