Week 7 NEC

Lakukan tugas rumah & ujian kamu dengan baik sekarang menggunakan Quizwiz!

The capacitor circuit conductor's ampacity shall be at least ______ % of the capaitor's rated current.

135

The combined length of one primary plus one secondary conductor (excluding any portion of the primary conductor protected at its ampacity) shall not exceed ____.

25 ft

Life safety branch installation and alternate power source connection shall provide that all functions (specified herein) be automatically restored to operation within ____ after interruption occurs.

10 seconds

Ground-fault protection of equipment shall be provided for solidly grounded wye electric services of more than 150 volts to ground but not exceeding ____ volts phase-to-phase for each service disconnect rated 1000 amperes or more.

1000

One transfer switch shall be permitted to serve one or more branches or systems in a facility with a maximum demand on the essential electrical system of ____.

150 kVA

Cartridge fuse and fuseholder overcurrent protection provisions are located in ____.

240.60 and 240.61

The tap conductor's ampacity shall not be less than the ______ on the circuits it supplies.

Combined calculated loads

The space within a patient room no less than 6ft beyond the bed's perimeter (in its normal location), and extending vertically no less than 71.2 ft from the floor is defined as the_______.

Patient Care Vicinity

____ branch circuits shall be protected at the motor nameplate current rating.

Torque motor

Demand calculations for generator set(s) sizing shall be based on the following: (1) prudent demand factors and historical data, (2) ____, (3) Article 220 feeder calculation procedures, or (4) any combination of the preceding.

connected load

Cable tray systems should be ____.

corrosion resistant

Where multiple power supplies serve the same dc system, the dc side of each power supply shall have a ____.

disconnecting means

All branch circuits serving patient care areas shall be provided with a(n) ____ by installation in a metal raceway system or a cable having a metallic armor or sheath assembly.

effective ground-fault current path

Receptacles located within the rooms, bathrooms, playrooms, activity rooms, and patient care areas of designated pediatric locations shall be either be listed tamper resistant or shall ____.

employ a listed tamper-resistant cover

A transformer vault door must be ____.

equipped with fully engaged locks

Electrical installation criteria and wiring methods for health care facilities are ____ for a standard commercial or industrial project.

far more specialized than

Minimum ampacity of arc welder conductors supplying a group of welders shall be based on ____ as determined in 630.11(A)

individual currents

Barriers are required in all service-entrance motor-control centers to ____ and terminals from the remainder of the motor-control center.

isolate service busbars

Requirements in 517.40(C) through 517.44 do not apply to freestanding buildings used as nursing homes and limited care facilities, provided that ____.

no surgical treatment requiring general anesthesia is offered

The branch circuit serving patient bed locations shall ____.

not be part of a multiwire branch circuit

The critical branch should include blood, bone and tissue banks, critical care systems, and ____.

nurse call systems

An alternate power source can be ____ driven by some form of prime mover(s).

on-site generator(s)

A transformer's primary conductor shall have an ampacity at least ________ of the feeder conductors' overcurrent device rating.

one-third

Means shall be provided to disconnect all conductors in a building (or other structure) from the ____.

service-entrance conductors

Generator accessories, including but not limited to, the ____, electrically operated louvers, and other generator accessories essential for generator operation, shall be arranged for automatic connection to the alternate power source.

transfer fuel pump


Set pelajaran terkait

Introduction to Operations and Supply Chain Strategy

View Set

AGEC 3413 test 3 (chapter 6 done and half of 7)

View Set

Chapter 1 Assessment/Review Questions

View Set