4th period MidTerm
On a bandsaw, how high above the material should the blade guide be adjusted?
1/8 inch to 1/4 inch
Which of the following is true of a 15 inch drill press?
15 inches is the maximum depth of cut
What is the maximum speed of the scroll saw?
1600 strokes per minute
In which year was the Occupational Safety and Health Administration established?
1971
Which of the following is an important step after evaluation has taken place?
Accounting for all employees
What precautions should be taken when using a disk/belt sander?
All of the above
Which of the following are fire hazards commonly found in the shop?
All of the above
When using chisels, you should always _________.
All of the above. 0
Criteria for identifying sockets include which of the following?
All of the above. 1
Which of the following is a true statement?
Anticipation can be accomplished by knowing the history of the work
What is the recommended way to stop bleeding on a cut or laceration?
Apply direct pressure to the wound
What is the primary use of a miter saw?
Both A and C
Which of the following completely surrounds the nut or bolt head?
Box-end wrench
Which of the following is a tool used to mark the location of a hole which is going to be drilled?
Center punch
What is the unit of measurement for expressing the intensity of sound?
Decibel
A combination square ____________.
Determines is something is square or at a 90 or 45 degree angle
A feeler gauge _____________.
Determines the clearance between the parts
Which of the following is the first preference in the hierarchy control?
Elimination of Hazard
A hacksaw blade should be installed with the teeth pointed away from the handle.
False
Face shields provide excellent eye protection.
False
It is not necessary to tighten all three positions of the chuck on a drill press/
False
Screwdrivers are the most common and least misused hand tools?
False
The miter guage cannot be used to cut 45 degrees tapers.
False
Three thread types are standard, national fine and national coarse.
False
When applying direct pressure, you should check the wound every few seconds.
False
When treating a person who has ingested a chemical, you should always induce vomiting.
False
How much do ball peens weigh?
Four to 12 ounces
Most chisels are made of __________.
High carbon steel
What should you do if a penetrating eye injury occurs?
Immobilize uninjured eye
Where can you find handling and emergency information on chemicals used in the shop?
Material safety data sheets
Which of the following is a chemical hazard?
Oxygen deficiency
Which of the following is a health-related hazard?
Radiation
The thickness of the cut in a planer is determined by which of the following?
Raising or lowering the table
Which of the following is NOT a responsibility of a worker involving the use of PPE?
Replacing damaged PPE
The jointer is designed to do which of the following?
To clean the edge of a board
What is the main purpose of the band saw?
To cut circles or irregular shapes
Drill Press: A larger drill bit requires the drill press to operate at a slower speed.
True
If a twist drill is not tightened properly in the chuck it may slip and damage the drill shank.
True
If caustic chemicals are spilled on the skin, the skin should always be flushed with water.
True
Nut drivers are sized according to the socket size on the end.
True
On all saws, the splitter keeps the saw kerf open.
True
One type of torque wrench is the one-half inch click-type ratcheting wrench.
True
The scroll saw is one of the safest power tools in the shop.
True
Which of the following is NOT a true statement?
Under OSHA law, Employees must provide their own personal protective equipment
Which of the following is a tip for welding safety?
Wear dry gloves
How are screwdrivers sized?
Width of blade
What mark appears on the frame of industrial quality safety glasses?
Z87
A planer is designed to __________ a board.
decrease the thickness of
