CCNA 2 CH 6

Which four steps are needed to configure a voice VLAN on a switch port?

- Configure the switch port in access mode. - Add a voice VLAN. - Assign the voice VLAN to the switch port. - Ensure that voice traffic is trusted and tagged with a CoS priority value.

Which two characteristics match extended range VLANs?

- VLAN IDs exist between 1006 to 4094. - They are saved in the running-config file by default.

A network administrator is determining the best placement of VLAN trunk links. Which two types of point-to-point connections utilize VLAN trunking? (Choose two.)

- between two switches that utilize multiple VLANs - between a switch and a server that has an 802.1Q NIC

What are three primary benefits of using VLANs? (Choose three.)

- security - cost reduction - improved IT staff efficiency

A small college uses VLAN 10 for the classroom network and VLAN 20 for the office network. What is needed to enable communication between these two VLANs while using legacy inter-VLAN routing?

A router with at least two LAN interfaces should be used.

A high school uses VLAN15 for the laboratory network and VLAN30 for the faculty network. What is required to enable communication between these two VLANs while using the router-on-a-stick approach?

A switch with a port that is configured as a trunk is needed when connecting to the router.

What two pieces of information are needed in a fully specified static route to eliminate recursive lookups? (Choose two.)

The interface ID exit interface The IP address of the next-hop neighbor

What is a characteristic of legacy inter-VLAN routing?

The router requires one Ethernet link for each VLAN.

What would be the first step in calculating a summarized route for 5 networks?

Write all network numbers in binary

Refer to the exhibit. The network engineer for the company that is shown wants to use the primary ISP connection for all external connectivity. The backup ISP connection is used only if the primary ISP connection fails. Which set of commands would accomplish this goal?

ip route 0.0.0.0 0.0.0.0 s0/0/0 ip route 0.0.0.0 0.0.0.0 s0/1/0 10

What is the correct syntax of a floating static route?

ip route 209.165.200.228 255.255.255.248 10.0.0.1 120

What command would be used to configure a static route on R1 so that traffic from both LANs can reach the 2001:db8:1:4::/64 remote network?

ipv6 route 2001:db8:1:4::/64 2001:db8:1:3::2

Which command is used to remove only VLAN 20 from a switch?

no vlan 20

Refer to the exhibit. In what switch mode should port G0/1 be assigned if Cisco best practices are being used?

trunk

Refer to the exhibit. The network administrator needs to configure a default route on the Border router. Which command would the administrator use to configure a default route that will require the least amount of router processing when forwarding packets?

Border(config)# ip route 0.0.0.0 0.0.0.0 s0/0/1

The network administrator configures the router with the ip route 172.16.1.0 255.255.255.0 172.16.2.2 command. How will this route appear in the routing table?

S 172.16.1.0 [1/0] via 172.16.2.2

When a Cisco switch receives untagged frames on a 802.1Q trunk port, which VLAN ID is the traffic switched to by default?

native VLAN ID

What happens to a port that is associated with VLAN 10 when the administrator deletes VLAN 10 from the switch?

The port becomes inactive.

Why would a floating static route be configured with an administrative distance that is higher than the administrative distance of a dynamic routing protocol that is running on the same router?

To be used as a backup route

When configuring a router as part of a router-on-a-stick inter-VLAN routing topology, where should the IP address be assigned?

To the subinterface

Which type of VLAN is used to designate which traffic is untagged when crossing a trunk port?

native

Refer to the graphic. Which command would be used on router A to configure a static route to direct traffic from LAN A that is destined for LAN C?

A(config)# ip route 192.168.4.0 255.255.255.0 192.168.3.2

Refer to the exhibit. Which is the best way for PC A and PC B to successfully communicate with sites on the Internet?

Configure a default route from R1 to ISP and a static route from ISP to R1.

Refer to the exhibit. What routing solution will allow both PC A and PC B to access the Internet with the minimum amount of router CPU and network bandwidth utilization?

Configure a static default route from R1 to Edge, a default route from Edge to the Internet, and a static route from Edge to R1.

What type of route allows a router to forward packets even though its routing table contains no specific route to the destination network?

Default route

Which type of static route that is configured on a router uses only the exit interface?

Directly connected static route

What is a disadvantage of using router-on-a-stick inter-VLAN routing?

Does not scale well beyond 50 VLANs

What must the network administrator do to remove Fast Ethernet port fa0/1 from VLAN 2 and assign it to VLAN 3?

Enter the switchport access vlan 3 command in interface configuration mode.

A Cisco switch currently allows traffic tagged with VLANs 10 and 20 across trunk port Fa0/5. What is the effect of issuing a switchport trunk allowed vlan 30 command on Fa0/5?

It allows only VLAN 30 on Fa0/5.

Consider the following command: ip route 192.168.10.0 255.255.255.0 10.10.10.2 5 How would an administrator test this configuration?

Manually shut down the router interface used as a primary route.

Port Fa0/11 on a switch is assigned to VLAN 30. If the command no switchport access vlan 30 is entered on the Fa0/11 interface, what will happen?

Port Fa0/11 will be returned to VLAN 1.

Refer to the exhibit. The small company shown uses static routing. Users on the R2 LAN have reported a problem with connectivity. What is the issue?

R1 needs a static route to the R2 LAN.

Refer to the exhibit. Which default static route command would allow R1 to potentially reach all unknown networks on the Internet?

R1(config)# ipv6 route ::/0 G0/1 fe80::2

Refer to the exhibit. R1 receives a packet destined for the IP address 192.168.2.10. Out which interface will R1 forward the packet?

Serial0/0/1

The ______________ command displays the VLAN assignment for all ports as well as the existing VLANs on the switch.

show vlan

Refer to the exhibit. DLS1 is connected to another switch, DLS2, via a trunk link. A host that is connected to DLS1 is not able to communicate to a host that is connected to DLS2, even though they are both in VLAN 99. Which command should be added to Fa0/1 on DLS1 to correct the problem?

switchport trunk native vlan 66

A company has several networks with the following IP address requirements: etc, etc, etc. Which block of addresses would be the minimum to accommodate all of these devices if each type of device was on its own network?

172.16.0.0/24

Which block of addresses would be the minimum to accommodate all of these devices if each type of device was on its own network?

172.16.0.0/24

Which two statements describe classful IP addresses?

The number of bits used to identify the hosts is fixed by the class of the network. All subnets in a network are the same size.

What happens to a static route entry in a routing table when the outgoing interface is not available?

The route is removed from the table.

Refer to the exhibit. Router RA receives a packet with a source address of 192.168.1.35 and a destination address of 192.168.1.85. What will the router do with this packet?

The router will forward the packet out interface FastEthernet 0/1.2.

What happens to a static route entry in a routing table when the outgoing interface associated with that route goes into the down state?

The static route is removed from the routing table.