Fall protection
Fall protection will be required when working in excess of feet above the ground.
6.
Which of the following should be used when 100% tie off is required?
LANYARD WITH TWO LINES
In fall prevention an example of an engineering control would be
A SCAFFOLD
Choosing an anchorage point at the highest point will minimize the:
ALL ANSWERS ARE CORRECT
Generally, equipment that has been exposed to a fall arrest force:
ALL ANSWERS ARE CORRECT
Performing as much work as possible at ground level minimizes:
ALL ANSWERS ARE CORRECT
Which of the following activities would require fall protection?
ALL ANSWERS ARE CORRECT
Which of the following are examples of situations where fall hazards may exist?
ALL ANSWERS ARE CORRECT
The best hazard control method is to design fall protection into the project:
BEFORE THEJOB
What is the correct inspection criteria for the below harness part: D ring / Buckles.
CRACKS, BREAKS, ROUGH SHARP EDGES
What is the correct inspection criteria for the below harness part Harness / Lanyard Webbing:
CUTS, BURNS, ABRASIONS, LOOSE STITCHES
It is ok to use a lanyard again after a fall.
FALSE
What is the correct inspection criteria for the below harness part / Thimble:
FIRMLY SEATED IN THE EYE
The purpose of a shock absorber on a lanyard is to:
REDUCE THE SPEED OF THE FALL
A full body harness should fit
SNUG
What is the correct inspection criteria for the below harness part / Hook Connector:
SPRING ACTION / KEEPER LATCH
The shock absorber end of the lanyard should be attached
TO THE HARNESS D RING
Persons riding in personnel baskets shall be tied off as indicated on the basket or per manufacturer's instruction. minimize
TRUE
Snap hooks should only be connected to the D-ring and anchor point.
TRUE
Whose responsibility is it to identify fall hazards and select the proper controls when necessary?
YOU / EMPLOYEE
Which of the following are types of fall protection?
ALL ANSWERS ARE CORRECT
Which of the following people can be contacted if a solid structure is not available for tying off?
ALL ANSWERS ARE CORRECT
Which of the following must meet ANSI or manufacturer specifications?
ALL MUST MEET THE SPECIFICATION