Fall protection

Fall protection will be required when working in excess of feet above the ground.

6.

Which of the following should be used when 100% tie off is required?

LANYARD WITH TWO LINES

In fall prevention an example of an engineering control would be

A SCAFFOLD

Choosing an anchorage point at the highest point will minimize the:

ALL ANSWERS ARE CORRECT

Generally, equipment that has been exposed to a fall arrest force:

ALL ANSWERS ARE CORRECT

Performing as much work as possible at ground level minimizes:

ALL ANSWERS ARE CORRECT

Which of the following activities would require fall protection?

ALL ANSWERS ARE CORRECT

Which of the following are examples of situations where fall hazards may exist?

ALL ANSWERS ARE CORRECT

The best hazard control method is to design fall protection into the project:

BEFORE THEJOB

What is the correct inspection criteria for the below harness part: D ring / Buckles.

CRACKS, BREAKS, ROUGH SHARP EDGES

What is the correct inspection criteria for the below harness part Harness / Lanyard Webbing:

CUTS, BURNS, ABRASIONS, LOOSE STITCHES

It is ok to use a lanyard again after a fall.

FALSE

What is the correct inspection criteria for the below harness part / Thimble:

FIRMLY SEATED IN THE EYE

The purpose of a shock absorber on a lanyard is to:

REDUCE THE SPEED OF THE FALL

A full body harness should fit

SNUG

What is the correct inspection criteria for the below harness part / Hook Connector:

SPRING ACTION / KEEPER LATCH

The shock absorber end of the lanyard should be attached

TO THE HARNESS D RING

Persons riding in personnel baskets shall be tied off as indicated on the basket or per manufacturer's instruction. minimize

TRUE

Snap hooks should only be connected to the D-ring and anchor point.

TRUE

Whose responsibility is it to identify fall hazards and select the proper controls when necessary?

YOU / EMPLOYEE

Which of the following are types of fall protection?

ALL ANSWERS ARE CORRECT

Which of the following people can be contacted if a solid structure is not available for tying off?

ALL ANSWERS ARE CORRECT

Which of the following must meet ANSI or manufacturer specifications?

ALL MUST MEET THE SPECIFICATION