rough terrain forklift
Per the chart shown the lifting capacity of the FB-40boom attachment at an 11-foot extension is
1,600 pounds
what is the appropriate length of time for an operator to wait after startup for the oil pressure light to extinguish before shutting down the engine
10 seconds
the ideal height for it the forklift when the forklift is traveling
12 to 18 inches
with the forklift tips extended forward 20 feet and at a height of 25 ft the maximum amount of weight the forklift should safely handle is
2000 lb
At shutdown,the forklift should be allowed to continue operating to cool the fluids for approximately
5 minutes
Maintenance time intervals for most machines that are adopted by manufacturers are established by
SAE
which is the leading cause of deadly forklift accident
a forklift roll over
when working in cold weather it is best to lubricate pivot points
at the end of the shift
in what position does a boom extension for lifting have the greatest lifting capacity
boom fully retracted and angled up to its maximum angle
when both front Outriggers are positioned and ready to lift the
front wheels should not be touching the ground at all
two wheel drive forklifts usually use
front wheels to drive in the rear wheels to steer
a forklift fitted with a FNR control typically has a
hydrostatic transmission
a hydrostatic transmission provides
infinitely variable speed
The purpose of a frame-leveling control is to
level the forklift by rotating the chassis on it's wheels and axles
when the operator is engaging the boom and hearing and immediate alarm during the process, it is probably the
load stability alarm
The movement being communicated to the operator is
lower the forks
The typical means of adjusting the length of a boom extension for lifting is
manually
the upright structure mounted on the front of a forklift on which the fork assembly travels up and down is called the
mast
the steering mode that allows all four wheels to turn and point in the same direction at the same time is called
oblique streering
power hop is caused or made worse by
operation on soil over a harder sub-layer
which of the following is a step in preparing a forklift for inspection
placing chocks under the wheel
to engage dog differential lock, the operator must
release pressure on the accelerator until the wheels stop spending, then engaged the switch
which position on the ignition switch is spring loaded to change positions when the operator releases it
start position
the one command that a forklift operator must respond to, even when it is someone other than the designated spotter, is
stop
if the forklift rear wheels start to lift off the ground with a load
stop raising the load and slowly lower it
When an operator is in a slippery area and one wheel is spinning while the other is motionless, the component or feature that should be engaged to help is
the differential lock
The Operators seat belt should be adjusted so that
the knees are silently bent when any pedal is fully depressed
given a chance which steering mode is best used for travel down a smooth road
two-wheel
