Troubleshooting High-Speed Data Service
IP multicast traffic is only sent to specific modem addresses on the network; IP broadcast traffic is sent to all modems on the network.
How does Internet protocol (IP) multicast differ from IP broadcast?
The International Telecommunication Union (ITU).
The first version of the Data Over Cable Service Interface Specification (DOCSIS) was approved as an international standard by what organization?
IP version 4 (IPv4), IP version 6 (IPv6), alternate provisioning mode (APM), and dual-stack provisioning mode (DPM).
What Internet protocol (IP) address modes can a Data Over Cable Service Interface Specification (DOCSIS) 3.0 and 3.1 modem be provisioned in?
Orthogonal frequency division multiplexing (OFDM) and low-density parity-check (LDPC).
What are two features that were added in Data Over Cable Service Interface Specification (DOCSIS) 3.1 to extend the viability of hybrid fiber/coax (HFC) networks into the next decade?
From the cable modem termination system (CMTS), which interfaces with the operations support system (OSS) and acts as a proxy or messenger that transfers messages and files between the modems and the respective servers.
Where do Data Over Cable Service Interface Specification (DOCSIS) modems receive their configuration files, billing system messages, and access control messages from?
The DOCSIS Media Access Control (MAC) Layer.
Which Data over Cable Service Interface Specification (DOCSIS) layer is used by the cable modem termination system (CMTS) to differentiate between cable modems?
The Physical and Data Link Layers.
Which Open Systems Interconnection (OSI) reference model layers does the Media Access Control (MAC) Layer in the Data Over Cable Service Interface Specification (DOCSIS) overlap so that the media access control (MAC) can be used by the cable modem termination system (CMTS) to differentiate between cable modems?
Compared to the downstream path, the narrower bandwidths and lower orders of modulation used to transport data over the return path cause the downstream and upstream data throughput to be unequal or asymmetrical.
In a Data Over Cable Service Interface Specification (DOCSIS) network, why is the data throughput over the return or upstream path typically less than the throughput of data over the forward or downstream path?
Time division multiple access (TDMA).
What communications access technology does the first version of the Data Over Cable Service Interface Specification (DOCSIS 1.0) use to send data upstream over the network's radio frequency (RF) return path?
Compliance with the DOCSIS standard and interoperability between suppliers.
What criteria does the Data Over Cable Service Interface Specification (DOCSIS) certification process ensure?
Layers 1 through 4 (Physical layer, Data Link Layer, Network Layer, and Transport Layer) are applied between the DOCSIS modem and CMTS.
What layers of the Open Systems Interconnection (OSI) reference model are specific to cable networks and are present only between Data Over Cable Service Interface Specification (DOCSIS) modems and the cable modem termination system (CMTS)?
Quality of service (QoS) controls, enhanced security, and adaptive equalization in the upstream path.
What requirements were needed for PacketCable to deliver a quality and reliable telephone service over a Data Over Cable Service Interface Specification (DOCSIS) access network?
The option to increase the top frequency of the upstream to 85 MHz.
What was introduced in Data Over Cable Service Interface Specification (DOCSIS) 3.0 to allow enough bandwidth for upstream carriers from previous DOCSIS versions?
76 Mbps.
What would be the downstream throughput if two quadrature amplitude modulation (QAM) channels with a throughput of 38 megabits per second (Mbps) were bonded?
The symptoms of the problem can be viewed, and any unusual screens or customer entries can be identified.
When analyzing a problem, what can the technician learn by asking the customer to show or demonstrate the problem?
32 dB or greater.
When using a digital signal analyzer to troubleshoot data throughput in the Data Over Cable Service Interface Specification (DOCSIS) network, what is the minimum modulation error ratio (MER) into the cable modem for a 256- quadrature amplitude modulation (QAM) carrier?
Step 1: Identify the problem.
Which step in the troubleshooting process requires a discussion with the customer to gather more detail about the problem?