Chapter 6 Exam Review

¡Supera tus tareas y exámenes ahora con Quizwiz!

R1(config)#

service password-encryption

R1>

enable

R1(config-if)#

ip address 192.168.4.4 255.255.255.0

Which two pieces of information are in the RAM of a Cisco router during normal operation? (Choose two.)

- Cisco IOS - IP routing table *The Cisco IOS file is stored in flash memory and copied into RAM during the boot up. The IP routing table is also stored in RAM. The basic diagnostic software is stored in ROM and the startup configuration file is stored in NVRAM.*

Which three commands are used to set up secure access to a router through a connection to the console interface? (Choose three.)

- login - password cisco - line console 0 *The three commands needed to password protect the console port are as follows:* *-line console 0* *-password cisco* *-login* *The interface fast ethernet 0/0 command is commonly used to access the configuration mode used to apply specific parameters such as the IP address to the Fa0/0 port. The line vty 0 4 command is used to access the configuration mode for Telnet. The 0 and 4 parameters specify ports 0 through 4, or a maximum of five simultaneous Telnet connections. The enable secret command is used to apply a password used on the router to access the privileged mode.*

What are two characteristics of IP? (Choose two.)

-does not require a dedicated end-to-end connection -operates independently of the network media *The Internet Protocol (IP) is a connectionless, best effort protocol. This means that IP requires no end-to-end connection nor does it guarantee delivery of packets. IP is also media independent, which means it operates independently of the network media carrying the packets.*

What routing table entry has a next hop address associated with a destination network?

-remote routes *Routing table entries for remote routes will have a next hop IP address. The next hop IP address is the address of the router interface of the next device to be used to reach the destination network. Directly-connected and local routes have no next hop, because they do not require going through another router to be reached.*

Which statement describes a hardware feature of a Cisco 1941 router that has the default hardware configuration?

It has two types of ports that can be used to access the console. *The connections in a Cisco 1941 router include two types of ports that are used for initial configuration and command-line interface management access. The two ports are the regular RJ-45 port and a new USB Type-B (mini-B USB) connector. In addition, the router has an AUX port for remote management access, and two Gigabit Ethernet interfaces for LAN access. Compact Flash can be used increase device storage, but it does not perform the functions of the CPU, which is required for operation of the device.*

Following default settings, what is the next step in the router boot sequence after the IOS loads from flash?

Locate and load the startup-config file from NVRAM. *There are three major steps to the router boot sequence: 1.Perform Power-On-Self-Test (POST) 2.Load the IOS from Flash or TFTP server 3.Load the startup configuration file from NVRAM

Which characteristic describes an IPv6 enhancement over IPv4?​

The IPv6 header is simpler than the IPv4 header is, which improves packet handling. *IPv6 addresses are based on 128-bit hierarchical addressing, and the IPv6 header has been simplified with fewer fields, improving packet handling. IPv6 natively supports authentication and privacy capabilities as opposed to IPv4 that needs additional features to support those. The IPv6 address space is many times bigger than IPv4 address space.*

A router boots and enters setup mode. What is the reason for this?

The configuration file is missing from NVRAM.

When a connectionless protocol is in use at a lower layer of the OSI model, how is missing data detected and retransmitted if necessary?

Upper-layer connection-oriented protocols keep track of the data received and can request retransmission from the upper-level protocols on the sending host. *When connectionless protocols are in use at a lower layer of the OSI model, upper-level protocols may need to work together on the sending and receiving hosts to account for and retransmit lost data. In some cases, this is not necessary, because for some applications a certain amount of data loss is tolerable.*

R1#

copy running-config startup-config

R1(config-line)#

login

Which characteristic of the network layer in the OSI model allows carrying packets for multiple types of communications among many hosts?

the ability to operate without regard to the data that is carried in each packet *The function of the network layer protocols specifies the packet structure and processing used to carry the data from one host to another host. The actual communication data is encapsulated in the network layer PDU. The feature of its operation without regard to the data carried in each packet allows the network layer to carry packets for multiple types of communications.*


Conjuntos de estudio relacionados

Chapter 3 - Corporate Governance

View Set

SEO - Search engine optimization

View Set