Patriot Tabs
Tab 71
( ) = RVA/PVA --> volume must be hostile ID
Tab 71
( ) = SPC --> volume must be friendly ID
Tab 13
1st tab in initialization sets tactical database in Tab 98
Tab 54
3 frequencies per unit provide full advantage if widely spaced: low (0-10), mid-band (11-20) and upper (21-31)
Tab 70
ACT settings are 1 - 8 (low missile procedures)
Tab 55
ALTERNATE SEARCH SECTOR CONTROL
Tab 4
ASOJ VIRTUAL TARGET CONTROL
Tab 5
ASSET / VOLUME STATUS CONTROL
Tab 34
COLD FIRE PREVENTION
Tab 2
COMMUNICATIONS CONTROL + TOD MASTER
Tab 74
COMPASS ROSE TABLES (direction)
Tab 32
CONTINUOUS DIAGNOSTIC CONTROL & REVIEW
Tab 76
COUNTER ARM THREAT PARAMETER
Tab 98
DATA BASE CONTROL
Tab 13
DATA BASE IN INITIALIZATION SELECTION
Tab 90
DATA COLLECTION CONTROL
Tab 68
DATA COMMUNICATIONS CONTROL
Tab 70
DEFENDED ASSETS
Tab 1
FIDOC + OPERATIONAL PARAMETERS
Tab 8
FP CONTROL
Tab 91
FP DATA ACQUISITION MODE SELECT / CONTROL
Tab 99
FP DATA TRANSFER CONTROL
Tab 72
GENERAL PURPOSE MAPS ENTRY
Ground Level Interference Filter
GLIF
Tab 94
HORIZON PLOT CONTROL
Tab 1
ID Mode: auto or manual
Tab 79
ID PARAMETERS authorized by Tab 1
ID- friend or foe Classification- ABT, TBM, ARM, etc
ID vs Classification
Tab 6
IFF / SIF CONTROL
Tab 72
IFFOF
Tab 96
INITIAL SEARCH LOWER BOUND
Tab 73
KAA-63 TABLE
Tab 78
LAUNCH DECISION PARAMETER
Tab 16
LAUNCHER FAULT DATA
Tab 63
LAUNCHER GROUP ASSIGNMENTS
Tab 85
LAUNCHER LOCATION / ALIGNMENT
Tab 7
LS CONTROL+ WIND SPEED
Tab 3
LS TEST RESULTS
Tab 97
MAPPING DISPLAY / CONTROL SELECT ENTRY
Tab 92
MASKED AREAS DRAWING CONTROL
Tab 76
P2. frequency diversity
Tab 5
P2. lists all hostile, friendly, weapon control & ID volumes + IFF line
Tab 54
P2. provides the pass/fail status of all frequencies organized by waveform code & frequency code
Tab 16
PACT 3 launchers only
Tab 54
RADAR FREQUENCY CONTROL
Tab 31
RADAR FUNCTIONS SUMMARY
Tab 81
RADAR LOCATION / ALIGNMENT DATA ENTRY
Tab 95
RADAR MAPPING TRAIN CONTROL + SUMMARY
Tab 9
REORIENTATION
Tab 14: ALT (A-D)
S/I that goes with boundaries of altitude bands
Tab 93
SECTOR MAPPING REVIEW CONTROL
Tab 56
TAILORED TBM SEARCH DATA
Tab 14
TARGET DISPLAY CONTROL
Tab 15
TBM DISCRIMINATION PARAMETERS
Tab 44
TBM THREAT SET CONTROL
Tab 30
TWT SELECT + TRANSMITTER BITE DATA
Tab 71
VOLUMES
Tab 54
Waveform Code (1-5) - 5 max Standard Frequency (0-31) - 32 max 160 total available frequencies
Tab 76
[CARM MODE] - system will select countermeasures
Tab 70
[Defended Areas]
Tab 54
[ECCM Enable]
Tab 72
[Masked Terrain Maps]
Tab 71
[WPNs CONTL] & [ID Assets]
Tab 85
[launcher graphic display]
Tab 5
activates Tabs 70 & 71
Tab 1
air defense warnings
Point, radio or a polygon
assets that can be entered in Tab 70
Tab 85
assigns groups for Tab 63
AD Warning: Red
attack is imminent or in progress
AD Warning: White
attack is not probable
AD Warning: Yellow
attack is probable
Tab 8
battleshoots radar - override all internal safety functions
range resolved
can't auto IFF something that is not ___________
Tab 76
continuously switching frequencies
Tab 73
covers 2 days of codes - 2 tables of 24 hrs each (time)
Tab 7
de-assign & store launchers (assign launchers in Tab 85)
Tab 70
defines the altitude above which ABTs are evaluated for threat against ABT assets (ACT of 8 or below)
point with diameter / multiple points
difference between radio and polygon assets entered in Tab 70
PACT 3
does Not use track-via-missile but KA Band as a guide/seeker (active seeker)
Tab 70
enter up to 3 TBMs & 6 ABTs
pre launch, launch, initial turn, mid course, terminal and interception
flight pattern of a missile
Tab 6: SIF table
heading: #3 & 4 effects Tab 73
Tab 1: slow target engage
heading: authorizes the local engagement of tracks with speeds below the "Minimum Speed Threshold for TBEQ" (slow movers)
Tab 1: GLIF
heading: blanks the detection of low level/ground level, slow moving clutter tracks. Example: cars
Tab 78: missile cut-off threshold
heading: defines missile thresholds for TBM and ABT low missile procedures
Tab 78: threat modifier altitude threshold
heading: defines the altitude above which ABTs are given an ATC of 10 (no threat) and below which ABTs are initially given an ATC of 9 (general threat) and then evaluated for threat against ABT assets (Tab 70)
Tab 78: missile preferences
heading: defines the missile selection priority for both one shot (shoot-look-shoot) and two shot (modified ripple or HI/LO ripple) engagements
Tab 81: UTM world model
heading: defines the where the starting point for a map is.
Tab 14: medium speed category
heading: determines the length of the speed and heading vectors displayed on ABT's
Tab 78: minimum speed threshold for TBEQ
heading: disallows engagements of ABT tracks with speeds equal to or less than the set minimum
Tab 91: long-term initialization
heading: for mapping and full tab sequence using an existing database
Tab 6: TBM/ASM IFF/SIF authorization
heading: interrogation upon initial detection &/or prior to engaging the track
Tab 91: short-term initialization
heading: only select tab sequences using an existing database small changes
Tab 91: standard emplacement with database
heading: radar emplacement, mapping and full tab sequence using an existing database
Tab 91: standard emplacement
heading: radar emplacement, mapping and full tab sequence with default entries new database @ a new site
Tab 1: alert state (green bar)
heading: signifies to ICC that the fire unit has assumed its COMMANDED alert state
Tab 1: refraction parameters
heading: takes into account the regions atmospheric condition for the radar AND curvature of the earth
Tab 14: medium speed category
heading: tracks above the HI speed display long vectors
Tab 14: medium speed category
heading: tracks below the LO speed display short vectors
Tab 14: medium speed category
heading: tracks between LO & HI speed display medium vectors
Tab 6: ABT IFF/SIF state
heading: tracks will automatically or manually be interrogated after crossing an active IFPID/IFFON line
Tab 71
need IFPID to auto IFF
Tab 54
only switches frequencies when being jammed
Tab 2
re-initialize RLRIU
Tab 14
select desired unit of measure for altitude & speed/range
Tab 2
select either radio or fiber as a communication link from a launcher to its controlling shelter
Tab 68
set RLRIU
Tab 9
slews launchers [launcher graphic display]
Tab 81
standard GPS starting point = WGS-84
Tab 98
tactical database set from Tab 13
Tab 76
targets classified as an ARM
Tab 76
track can be classified as ARM carrier by ICC
Tab 8
updates K7 database
Tab 72
used for display
Spurious TBM
user recognizes fake TBM on scope but the system doesn't. Therefore, place [Engage Hold] on target to cease auto engagements
PACT 2
uses radar to acquire a missile. Also uses track-via-missile as a guide
hold, tight and free
weapons control status
engage anything not ID as friendly
weapons control status: free
engagement orders from higher OR self defense
weapons control status: hold
only engage if (+) ID as hostile
weapons control status: tight
Tab 56
works with Tab 44
Tab 70
works with Tab 5 P1 effects the system
Tab 71
works with Tab 5 P2 effects the system
Tab 76
works with Tab 54
Tab 44
works with Tab 56 for tailoring the radar/set the area This is based on the Threat Launch Area (TLA) size of the asset & on the threats
Tab 54
works with Tab 76
