Patriot Tabs

अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!

Tab 71

( ) = RVA/PVA --> volume must be hostile ID

Tab 71

( ) = SPC --> volume must be friendly ID

Tab 13

1st tab in initialization sets tactical database in Tab 98

Tab 54

3 frequencies per unit provide full advantage if widely spaced: low (0-10), mid-band (11-20) and upper (21-31)

Tab 70

ACT settings are 1 - 8 (low missile procedures)

Tab 55

ALTERNATE SEARCH SECTOR CONTROL

Tab 4

ASOJ VIRTUAL TARGET CONTROL

Tab 5

ASSET / VOLUME STATUS CONTROL

Tab 34

COLD FIRE PREVENTION

Tab 2

COMMUNICATIONS CONTROL + TOD MASTER

Tab 74

COMPASS ROSE TABLES (direction)

Tab 32

CONTINUOUS DIAGNOSTIC CONTROL & REVIEW

Tab 76

COUNTER ARM THREAT PARAMETER

Tab 98

DATA BASE CONTROL

Tab 13

DATA BASE IN INITIALIZATION SELECTION

Tab 90

DATA COLLECTION CONTROL

Tab 68

DATA COMMUNICATIONS CONTROL

Tab 70

DEFENDED ASSETS

Tab 1

FIDOC + OPERATIONAL PARAMETERS

Tab 8

FP CONTROL

Tab 91

FP DATA ACQUISITION MODE SELECT / CONTROL

Tab 99

FP DATA TRANSFER CONTROL

Tab 72

GENERAL PURPOSE MAPS ENTRY

Ground Level Interference Filter

GLIF

Tab 94

HORIZON PLOT CONTROL

Tab 1

ID Mode: auto or manual

Tab 79

ID PARAMETERS authorized by Tab 1

ID- friend or foe Classification- ABT, TBM, ARM, etc

ID vs Classification

Tab 6

IFF / SIF CONTROL

Tab 72

IFFOF

Tab 96

INITIAL SEARCH LOWER BOUND

Tab 73

KAA-63 TABLE

Tab 78

LAUNCH DECISION PARAMETER

Tab 16

LAUNCHER FAULT DATA

Tab 63

LAUNCHER GROUP ASSIGNMENTS

Tab 85

LAUNCHER LOCATION / ALIGNMENT

Tab 7

LS CONTROL+ WIND SPEED

Tab 3

LS TEST RESULTS

Tab 97

MAPPING DISPLAY / CONTROL SELECT ENTRY

Tab 92

MASKED AREAS DRAWING CONTROL

Tab 76

P2. frequency diversity

Tab 5

P2. lists all hostile, friendly, weapon control & ID volumes + IFF line

Tab 54

P2. provides the pass/fail status of all frequencies organized by waveform code & frequency code

Tab 16

PACT 3 launchers only

Tab 54

RADAR FREQUENCY CONTROL

Tab 31

RADAR FUNCTIONS SUMMARY

Tab 81

RADAR LOCATION / ALIGNMENT DATA ENTRY

Tab 95

RADAR MAPPING TRAIN CONTROL + SUMMARY

Tab 9

REORIENTATION

Tab 14: ALT (A-D)

S/I that goes with boundaries of altitude bands

Tab 93

SECTOR MAPPING REVIEW CONTROL

Tab 56

TAILORED TBM SEARCH DATA

Tab 14

TARGET DISPLAY CONTROL

Tab 15

TBM DISCRIMINATION PARAMETERS

Tab 44

TBM THREAT SET CONTROL

Tab 30

TWT SELECT + TRANSMITTER BITE DATA

Tab 71

VOLUMES

Tab 54

Waveform Code (1-5) - 5 max Standard Frequency (0-31) - 32 max 160 total available frequencies

Tab 76

[CARM MODE] - system will select countermeasures

Tab 70

[Defended Areas]

Tab 54

[ECCM Enable]

Tab 72

[Masked Terrain Maps]

Tab 71

[WPNs CONTL] & [ID Assets]

Tab 85

[launcher graphic display]

Tab 5

activates Tabs 70 & 71

Tab 1

air defense warnings

Point, radio or a polygon

assets that can be entered in Tab 70

Tab 85

assigns groups for Tab 63

AD Warning: Red

attack is imminent or in progress

AD Warning: White

attack is not probable

AD Warning: Yellow

attack is probable

Tab 8

battleshoots radar - override all internal safety functions

range resolved

can't auto IFF something that is not ___________

Tab 76

continuously switching frequencies

Tab 73

covers 2 days of codes - 2 tables of 24 hrs each (time)

Tab 7

de-assign & store launchers (assign launchers in Tab 85)

Tab 70

defines the altitude above which ABTs are evaluated for threat against ABT assets (ACT of 8 or below)

point with diameter / multiple points

difference between radio and polygon assets entered in Tab 70

PACT 3

does Not use track-via-missile but KA Band as a guide/seeker (active seeker)

Tab 70

enter up to 3 TBMs & 6 ABTs

pre launch, launch, initial turn, mid course, terminal and interception

flight pattern of a missile

Tab 6: SIF table

heading: #3 & 4 effects Tab 73

Tab 1: slow target engage

heading: authorizes the local engagement of tracks with speeds below the "Minimum Speed Threshold for TBEQ" (slow movers)

Tab 1: GLIF

heading: blanks the detection of low level/ground level, slow moving clutter tracks. Example: cars

Tab 78: missile cut-off threshold

heading: defines missile thresholds for TBM and ABT low missile procedures

Tab 78: threat modifier altitude threshold

heading: defines the altitude above which ABTs are given an ATC of 10 (no threat) and below which ABTs are initially given an ATC of 9 (general threat) and then evaluated for threat against ABT assets (Tab 70)

Tab 78: missile preferences

heading: defines the missile selection priority for both one shot (shoot-look-shoot) and two shot (modified ripple or HI/LO ripple) engagements

Tab 81: UTM world model

heading: defines the where the starting point for a map is.

Tab 14: medium speed category

heading: determines the length of the speed and heading vectors displayed on ABT's

Tab 78: minimum speed threshold for TBEQ

heading: disallows engagements of ABT tracks with speeds equal to or less than the set minimum

Tab 91: long-term initialization

heading: for mapping and full tab sequence using an existing database

Tab 6: TBM/ASM IFF/SIF authorization

heading: interrogation upon initial detection &/or prior to engaging the track

Tab 91: short-term initialization

heading: only select tab sequences using an existing database small changes

Tab 91: standard emplacement with database

heading: radar emplacement, mapping and full tab sequence using an existing database

Tab 91: standard emplacement

heading: radar emplacement, mapping and full tab sequence with default entries new database @ a new site

Tab 1: alert state (green bar)

heading: signifies to ICC that the fire unit has assumed its COMMANDED alert state

Tab 1: refraction parameters

heading: takes into account the regions atmospheric condition for the radar AND curvature of the earth

Tab 14: medium speed category

heading: tracks above the HI speed display long vectors

Tab 14: medium speed category

heading: tracks below the LO speed display short vectors

Tab 14: medium speed category

heading: tracks between LO & HI speed display medium vectors

Tab 6: ABT IFF/SIF state

heading: tracks will automatically or manually be interrogated after crossing an active IFPID/IFFON line

Tab 71

need IFPID to auto IFF

Tab 54

only switches frequencies when being jammed

Tab 2

re-initialize RLRIU

Tab 14

select desired unit of measure for altitude & speed/range

Tab 2

select either radio or fiber as a communication link from a launcher to its controlling shelter

Tab 68

set RLRIU

Tab 9

slews launchers [launcher graphic display]

Tab 81

standard GPS starting point = WGS-84

Tab 98

tactical database set from Tab 13

Tab 76

targets classified as an ARM

Tab 76

track can be classified as ARM carrier by ICC

Tab 8

updates K7 database

Tab 72

used for display

Spurious TBM

user recognizes fake TBM on scope but the system doesn't. Therefore, place [Engage Hold] on target to cease auto engagements

PACT 2

uses radar to acquire a missile. Also uses track-via-missile as a guide

hold, tight and free

weapons control status

engage anything not ID as friendly

weapons control status: free

engagement orders from higher OR self defense

weapons control status: hold

only engage if (+) ID as hostile

weapons control status: tight

Tab 56

works with Tab 44

Tab 70

works with Tab 5 P1 effects the system

Tab 71

works with Tab 5 P2 effects the system

Tab 76

works with Tab 54

Tab 44

works with Tab 56 for tailoring the radar/set the area This is based on the Threat Launch Area (TLA) size of the asset & on the threats

Tab 54

works with Tab 76


संबंधित स्टडी सेट्स

Chapter 17: Government and Politics

View Set

Biology: Fall 2015 Final Exam (15-19) FI

View Set

Ricci Chapter 50: Nursing Care of the Child With an Alteration in Behavior, Cognition, Development, or Mental Health/Cognitive or Mental Health Disorder

View Set

Fundamentals of Information Security - C836: Pre-Assessment:

View Set