8.3.5 EIGRPv6

Which of the following are the first two steps in configuring EIGRPv6? (Select two.)

Set the router ID using eigrp router-id [a.b.c.d] Enable EIGRP using ipv6 router eigrp [ASN#]

Which command is used to enable EIGRPv6?

ipv6 router eigrp [ASN]

Which command is used to configure load balancing in EIGRPv6?

maximum-paths

Your routers have been configured to use EIGRPv6. While troubleshooting a routing issue, you decide that you need to view a list of neighbors on each router. Which command should you use to do this?

show ipv6 eigrp neighbors

Your routers have been configured to use EIGRPv6. While troubleshooting a routing issue, you decide that you need to view successor information on each router. Which command should you use to do this?

show ipv6 eigrp topology

Your routers have been configured to use EIGRPv6. While troubleshooting a routing issue, you decide that you need to view the current state of the IPv6 routing protocol processes on each router. Which command should you use to do this?

show ipv6 protocols

Which of the following configurations need to be set for EIGRPv6 to work properly? (Select two.)

ACLs are not blocking EIGRPv6 message. EIGRPv6 is enabled on interfaces.

Which of the following configurations must be set to ensure neighbor relationships can be formed with EIGRPv6?

Authentication is correct. EIGRPv6 is enabled on all devices.

You are planning to implement IPv6 in your organization's network. As a result, you must migrate your routing protocol from EIGRPv4 to EIGRPv6. Which of the following are issues you must keep in mind during the migration process? (Select two.)

Auto-summarization is not needed in EIGRPv6. EIGRPv6 advertises IPv6 prefixes instead of IPv4 subnets.

Which command is used to set router ID in EIGRPv6?

eigrp router-id [ID number]