How to not pass the CCNA ch 9
Refer to the exhibit. A network engineer is troubleshooting host connectivity on a LAN that uses a first hop redundancy protocol. Which IPv4 gateway address should be configured on the host?
192.168.2.100
A Cisco proprietary FHRP that provides load sharing in addition to redundancy
GLBP
Refer to the exhibit. What protocol can be configured on gateway routers R1 and R2 that will allow traffic from the internal LAN to be load balanced across the two gateways to the Internet?
GLBP
Which FHRP implementation is a Cisco-proprietary protocol that suppports IPv4 load sharing?
GLBP
Which FHRP implementation is a Cisco-proprietary protocol that suppports IPv6 load balancing?
GLBP for IPv6
A Cisco proprietary FHRP that provides redundancy through use of an active device and standby device
HSRP
Which FHRP implementation is a nonproprietary protocol which relies on ICMP to provide IPv4 redundancy?
IRDP
Which statement describes HSRP?
It is used within a group of routers for selecting an active device and a standby device to provide gateway services to a LAN.
Refer to the exhibit. Which destination MAC address is used when frames are sent from the workstation to the default gateway?
MAC address of the virtual router
The forwarding router fails (STEP# 1-4)
Step 1
The standby router stops seeing hello messages from the forwarding router (STEP# 1-4)
Step 2
The standby router assumes the role of the forwarding router (STEP# 1-4)
Step 3
An open standard FHRP that provides redundancy through use of a virtual routers master and one or more backups
VRRP
A network administrator is analyzing the features that are supported by different first-hop router redundancy protocols. Which statement describes a feature that is associated with HSRP?
HSRP uses active and standby routers.
The new forwarding router assumes both the IP and MAC addresses of the virtual router (STEP# 1-4)
Step 4