Manufacturing Processes: Fundamentals of Metal Forming (CH. 17)

Pataasin ang iyong marka sa homework at exams ngayon gamit ang Quizwiz!

Which of the following are desirable properties of the work material in metal forming: (a) high ductility, (b) high tensile strength, (c) high yield strength, (d) low ductility, (e) low tensile strength, and (f) low yield strength?

Answer. (a) and (f).

Which of the following are advantages and characteristics of hot working relative to cold working (four correct answers): (a) fracture of workpart is less likely, (b) friction is reduced, (c) increased strength properties, (d) isotropic mechanical properties, (e) less overall energy is required, (f) lower deformation forces are required, (g) more significant shape changes are possible, and (h) strain-rate sensitivity is reduced?

Answer. (a), (d), (f), and (g).

Stresses applied in most metal forming operations are which one of the following: (a) compressive, (b) shear, or (c) tensile?

Answer. (a).

The coefficient of friction between the part and the tool in cold working tends to be (a) higher, (b) lower, or (c) no different relative to its value in hot working?

Answer. (b).

The flow curve expresses the behavior of a metal in which of the following regions of the stress-strain curve: (a) elastic region or (b) plastic region?

Answer. (b).

Which of the following is typical of the starting work geometry in sheet metal processes: (a) high volume-to-area ratio or (b) low volume-to-area ratio?

Answer. (b).

Which of the following are bulk deformation processes (three correct answers): (a) bending, (b) deep drawing, (c) extrusion, (d) forging, (e) rolling, and (f) shearing?

Answer. (c), (d), and (e).

1Increasing strain rate tends to have which one of the following effects on flow stress during hot forming of metal: (a) decreases flow stress, (b) has no effect, or (c) increases flow stress?

Answer. (c).

Hot working of metals refers to which one of the following temperature regions relative to the melting point of the given metal: (a) room temperature, (b) 0.2Tm, (c) 0.4Tm, or (d) 0.6Tm, where Tm = the melting temperature on an absolute temperature scale?

Answer. (d).

The average flow stress is the flow stress multiplied by which of the following factors: (a) n, (b) (1+n), (c) 1/n, or (d) 1/(1+n), where n is the strain-hardening exponent?

Answer. (d).


Kaugnay na mga set ng pag-aaral

CH14 GROUP HEALTH AND BLANKET INS

View Set

NIH Stroke Scale Group B Patient 1-6

View Set

*Mcgraw Hill BIO425 Chapter 10 Muscular System

View Set

Ch. 7 Supplier Relationship Management (SRM)

View Set

Random MC questions I found online - test 1

View Set

Chapter 13: Exporting and Global Sourcing

View Set