Chapter 4: Network Access

अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!

The throughput of a FastEthernet network is 80 Mb/s. The traffic overhead for establishing sessions, acknowledgments, and encapsulation is 15 Mb/s for the same time period. What is the goodput for this network?

65 Mbps

A network administrator is required to upgrade wireless access to end users in a building. To provide data rates up to 1.3 Gb/s and still be backward compatible with older devices, which wireless standard should be implemented?

802.11ac*

What is one advantage of using fiber optic cabling rather than copper cabling?

It is able to carry signals much farther than copper cabling.*

As data travels on the media in a stream of 1s and 0s how does a receiving node identify the beginning and end of a frame?​

The transmitting node inserts start and stop bits into the frame

refer to the exibit of wire

The untwisted length of each wire is too long.*

Why are two strands of fiber used for a single fiber optic connection

They allow for full-duplex connectivity.*

Which layer of the OSI model is responsible for specifying the encapsulation method used for specific types of media?

data link

efer to the exhibit. The PC is connected to the console port of the switch. All the other connections are made through FastEthernet links. Which types of UTP cables can be used to connect the devices?​

1 - rollover, 2 - straight-through, 3 - crossover*

10,000,000,000 b/s can also be written as

10 Gbps

What are two characteristics of 802.11 wireless networks? (Choose two.

Collisions can exist in the networks. * They use CSMA/CA technology.*

What is one main characteristic of the data link layer?

It shields the upper layer protocol from being aware of the physical medium to be used in the communication.*

What acronym is used to reference the data link sublayer that identifies the network layer protocol encapsulated in the frame?

LLC

What is true concerning physical and logical topologies?

Logical topologies determine the media access control method used.*

What is true concerning physical and logical topologies?

Logical topologies refer to how a network transfers data between devices

A network administrator notices that some newly installed Ethernet cabling is carrying corrupt and distorted data signals. The new cabling was installed in the ceiling close to fluorescent lights and electrical equipment. Which two factors may interfere with the copper cabling and result in signal distortion and data corruption? (Choose two.)

RFI EMI

Which statement is correct about multimode fiber?

SC-SC patch cords are used with multimode fiber cables.*

Which statement describes signaling at the physical layer?

Sending the signals asynchronously means that they are transmitted without a clock signal.

he term "........." indicates the capacity of a medium to carry data and it is typically measured in kilobits per second (kb/s) or megabits per second (Mb/s).​

bandwidth

How is the magnetic field cancellation effect enhanced in UTP cables?

by increasing and varying the number of twists in each wire pair*

A network administrator is designing the layout of a new wireless network. Which three areas of concern should be accounted for when building a wireless network? (Choose three.)

coverage area* interference* security

What is the purpose of the FCS field in a frame?

to determine if errors occurred in the transmission and reception

What are two reasons for physical layer protocols to use frame encoding techniques? (Choose two.)

to identify where the frame starts and ends* to distinguish data bits from control bits*


संबंधित स्टडी सेट्स

Science Exams Midterms Chapter 4

View Set

NUR102 - Chp. 61 - Caring for Clients Requiring Orthopedic Treatment

View Set

Friendship in Childhood and Adolescence

View Set

F215 - Cellular Control & Biotechnology and Gene Technologies

View Set