Cisco Final Study Set C-2
Which mode configuration setting would allow formation of an EtherChannel link between switches SW1 and SW2 without sending negotiation traffic?
SW1: on SW2: on
Which statement describes the autonomous system number used in EIGRP configuration on a Cisco router?
It functions as a process ID in the operation of the router.
Refer to the exhibit. What will Router1 do if it receives packets that are destined to network 2001:db8:11:100::/64?
drop the packets
What two values must match between two EIGRP directly connected neighbors to establish and maintain an adjacency? (Choose two.)
-metric parameters -autonomous system number
Which protocol does EIGRP use for the transportation of EIGRP packets?
Reliable Transport Protocol
What is a key distinction between classful and classless routing protocols?
Classful routing protocols do not send subnet mask information in their routing updates.
A network administrator is analyzing first-hop router redundancy protocols. What is a characteristic of VRRPv3?
It supports IPv6 and IPv4 addressing.
Refer to the exhibit. A network administrator has configured OFPF in the topology as shown. What is the preferred path to get from the LAN network that is connected to R1 to the LAN network that is connected to R7?
R1-R3-R4-R5-R6-R7
Which two statements are correct about EIGRP acknowledgment packets? (Choose two.)
-The packets are sent as unicast. -The packets are unreliable.
Refer to the exhibit. Which two conclusions can be derived from the output? (Choose two.)
-There is one feasible successor to network 192.168.1.8/30. -The neighbor 172.16.6.1 meets the feasibility condition to reach the 192.168.1.0/24 network.
What are two load-balancing methods in the EtherChannel technology? (Choose two.)
-source IP to destination IP -source MAC to destination MAC
Which two parameters must match on the ports of two switches to create a PAgP EtherChannel between the switches? (Choose two.)
-speed -VLAN information
Refer to the exhibit. A network administrator would like to implement dynamic routing within a small network environment as shown in the exhibit. Which routing protocol would be a viable solution?
EIGRP
A network engineer examining the operation of EIGRP on a router notices that one particular route is in an active state. What can the engineer determine about this route?
EIGRP query messages are being sent to other routers requesting paths to this network.
How are externally learned EIGRP routes identified in the routing table?
EX
Which is a characteristic of EtherChannel?
STP treats all interfaces in a bundle as a single logical link.
A network administrator has configured an EtherChannel between two switches that are connected via four trunk links. If the physical interface for one of the trunk links changes to a down state, what happens to the EtherChannel?
The EtherChannel will remain functional.
Which command is used to display the bandwidth of an interface on an EIGRP-enabled router?
The best alternative backup route is immediately inserted into the routing table.
What does the SPF algorithm consider to be the best path to a network?
The path that includes the fastest cumulative bandwidth links.
What EIGRP packet type is used by EIGRP routers to discover neighbors on directly connected links?
hello
