Module 10 Test Questions
A network administrator requires access to manage routers and switches locally and remotely. Which connection is used for remote access via a dialup connection? SSH Console FTP AUX Telnet
AUX. (pg. 19)
A network administrator requires access to manage routers and switches locally and remotely. Which connection is the preferred out-of-band access method? SSH Console FTP AUX Telnet
Console. (pg. 19)
A new network administrator has been asked to enter a banner message on a Cisco device. What is the fastest way a network administrator could test whether the banner is properly configured? Reboot the device Enter CTRL-Z at the privileged mode prompt Exit global configuration mode Power cycle the device Exit privileged EXEC mode and press Enter
Exit privileged EXEC mode and press Enter. (pg. 14)
In phase 2 which function happen during the boot up process of a Cisco router? Enter setup mode Locates and loads the Cisco IOS software Locate and load the startup configuration file Perform the POST and load the bootstrap program
Locates and loads the Cisco IOS software. (pg. 9)
In phase 3 which function happen during the boot up process of a Cisco router? Enter setup mode Locates and loads the Cisco IOS software Locates and loads the startup configuration file Perform the POST and load the bootstrap program
Locates and loads the startup configuration file. (pg. 9)
What is NVRAM?
Non-volatile memory used as permanent storage (when power is removed) for the startup configuration file (startup-config). (Pg. 5)
Which two functions are primary functions of a router? Packet forwarding Microsegmentation Domain name resolution Path selection Flow control
Packet forwarding Path selection (pg. 36)
In phase 1 which function happen during the boot up process of a Cisco router? Enter setup mode Locates and loads the Cisco IOS software Locate and load the startup configuration file Perform the POST and load the bootstrap program
Performs the POST and load the bootstrap program. (pg. 9)
Which configuration mode is the copy running-config startup-config command used in? R1(config-line)# R1# R1(config-router)# R1> R1(config)#
R1# (pg. 23)
In which mode is the "copy running-config startup-config" command used in? R1(config)# R1> R1(config-router)# R1# R1(config-line)# R1(config-if)#
R1#. (pg. 15)
Which configuration mode is the interface fastethernet 0/0 command used in? R1(config-line)# R1# R1(config-router)# R1> R1(config)#
R1(config)# (pg. 23)
In which mode is the "service password-encryption" command used in? R1(config)# R1> R1(config-router)# R1# R1(config-line)# R1(config-if)#
R1(config)#. (pg. 15)
In which mode is the "ip address 192.168.4.4 255.255.255.0" command used in? R1(config)# R1> R1(config-router)# R1# R1(config-line)# R1(config-if)#
R1(config-if)#. (pg. 15)
Which configuration mode is the login command used in? R1(config-line)# R1# R1(config-router)# R1> R1(config)#
R1(config-line)# (pg. 23)
In which mode is the "login" command used in? R1(config)# R1> R1(config-router)# R1# R1(config-line)# R1(config-if)#
R1(config-line)#. (pg. 15)
A router boots and enters setup mode. What is the reason for this? The IOS image is corrupt Cisco IOS is missing from flash memory The configuration file is missing from NVRAM the POST process has detected hardware failure
The configuration file is missing from NVRAM. (pg. 8)
What will happen if the default gateway address is incorrectly configured on a host? The host cannot communicate with other hosts in the local network The switch will not forward packets initiated by the host The host will have to use ARP to determine the correct address of the default gateway The host cannot communicate with hosts in other networks A ping from the host to 127.0.0.1 would not be successful
The host cannot communicate with hosts in other networks. (pg. 39)
What are two functions of NVRAM? To store the routing table To retain contents when power is removed To store the startup configuration file To contain the running configuration file To store the ARP table
To retain contents when power is removed To store the startup configuration file. (pg. 10)
What is the command to configure an IPv4 default gateway on a switch?
ip default-gateway 192.168.10.1 (pg. 35)
Which three commands are used to set up secure access to a router through a connection to the console interface? interface fastethernet 0/0 line vty 0 4 line console 0 enable secret cisco login password cisco
line console 0 login password cisco. (pg. 16)
Which configuration mode is the enable command used in? R1(config-line)# R1# R1(config-router)# R1> R1(config)#
R1> (pg. 23)
In which mode is the "enable" command used in? R1(config)# R1> R1(config-router)# R1# R1(config-line)# R1(config-if)#
R1>. (pg. 15)
Which command displays a message when the router is accessed? Router(config)# hostname CL1 Router(config)# enable password Cisco Router(config-line)# password class Router(config)# password Cisco Router(config)# banner motd #
Router(config)# banner motd #. (pg. 13)
Which command configures a name on the router? Router(config)# hostname CL1 Router(config)# enable password Cisco Router(config-line)# password class Router(config)# password Cisco Router(config)# banner motd #
Router(config)# hostname CL1. (pg. 13)
Which command provides security on the console? Router(config)# hostname CL1 Router(config)# enable password Cisco Router(config-line)# password class Router(config)# password Cisco Router(config)# banner motd #
Router(config-line)# password class. (pg. 13)
A network administrator requires access to manage routers and switches locally and remotely. Which connection is a remote access method which uses encryption? SSH Console FTP AUX Telnet
SSH. (pg. 19)
A network administrator requires access to manage routers and switches locally and remotely. Which connection is an unsecure remote access method? SSH Console FTP AUX Telnet
Telnet. (pg. 19)
In a trace route command, which IP address does the user PC target in order to forward its data off the local network? The 1st IP address The 2nd IP address The 3rd IP address The 4th IP address
The 1st IP address. (pg. 38)
