bruh
A is attached to a device (switch) box with ___ screws.
6-32
A plug is the same as a receptacle.
false
Refer to Figure 119.85. The receptacle is controlled with the switches.
false
Refer to Figure 112.711. The upper half of the receptacle is controlled by Switch ___.
neither 1 nor 2
Lighted handle toggle switches utilize a neon lamp that is illuminated when the switch is in the ___ position.
off
Refer to Figure 119.712. When Switch 1 is OFF and Switch 2 is ON, Luminaire A should be ___.
on
Refer to Figure 112.020. In Diagram II, are the conductors correctly connected so that the light can be controlled from either switch?
yes
Refer to Figure 112.413. Although most switches can be used to control motor loads, this switch with a 15-amp rating can control a ___ motor at 240 volts
2 hp
How many 4-way switches are required to control a light from five locations?
3
DPST is an abbreviation for ___-___.
Double Pole- Single Throw
Which of the connection diagrams shown in Figure 120.101 is correct? The receptacle is used for holiday lighting and controlled with the photocell. The porch light is controlled from the switches. The flag pole light is constantly "hot."
I only
Refer to Figure 112.040. Which wiring diagram is correctly connected for a lighted handle (illuminated) switch?
II
The operation diagram for a three-way switch is shown at ___ in Figure 112.005.
II
Refer to Figure 112.060. The lamp will be "OFF" with the three-way switches in the positions shown in Diagram(s) ___.
II & IV only
Drawing ___ in Figure 112.415 is an framed toggle-type switch.
V
Drawing ___ in Figure 112.415 is a key-lock (not locking) type switch.
VI
Which of these is a type of lighting switch?
any of these
As shown at PL in Figure 112.021, pilot light switches ___.I. require a neutral II. are illuminated when the switch is ON
both I & II
Drawing ___ shows the photocell correctly connected.
both I & II
Excluding any grounding terminals, a double-pole (single-throw) switch has ___ terminal screws.
four
Tamper-resistant receptacles ___.
have built-in shutters to prevent insertion of anything into one slot only
The ungrounded conductor is often called the ____.
hot
If a receptacle has a NEMA designation that is L8-30R, this indicates that the receptacle can be mated with a ___-type plug attached to a flexible cord.
locking
"Silent" or "Quiet" switches can be operated on AC circuits only because the switch contacts open ___ than a switch that is rated to break DC current.
more slowly
The switch element at Point C in Figure 112.411 is the ___ of the switch.
mounting strap
Refer to Figure 128.110. Which of the drawings shows the (3-lamp) 2 × 4 luminaire correctly connected? The "outboard" or 2-lamp ballast is to be controlled from switch #1 and the "inboard" or 1-lamp ballast is to be controlled from switch #2.
neither I nor II
Which of the drawings shown in Figure 128.111 has the (3-lamp) 2 × 4 luminaire correctly connected? The "inboard" or 1-lamp ballast is to be controlled from switch #1 and the "outboard" or 2-lamp ballast is to be controlled from switch #2.
neither I nor II
The grounded conductor in a 120-volt circuit is typically known as the ___.
neutral
A device with an 11-30P NEMA designation indicates that this device is a ___.
plug
If a receptacle has a NEMA designation that is 15-50R, this indicates that the receptacle can be mated with a ___-type plug attached to a flexible cord.
straight blade
To convert a conventional duplex receptacle into a split-wired receptacle, the ___ is removed.
tab
On a switch, the actuator is ___.
the handle used to turn the switch ON and OFF
SPDT switches are commonly called "___-___" switches.
three-way
Controlling a light from two locations requires two _____
three-way switches
Figure 112.414 The catalog information for a manual motor switch is shown in Figure 112.414. One of these DPST switches can be used as the disconnecting means for a 7 HP 1Ø motor operating at 480 volts
true
Hospital grade receptacles have a higher impact resistance than other grades of receptacles.
true
A single-pole, single-throw switch has ___ screw terminals for the connection of current-carrying circuit conductors.
two