Hybrid-Electrical Applications (AD12-105-2.0.1) UNIT 5 QUIZ STUDY GUIDE
The CAN communication network uses ______________.
2 wires
Electronic transmissions are __________________________.
Are shifted and have fluid pressure controlled by solenoids.
The ___________ communication network uses 2 wires.
CAN
A __________ can be used to diagnose a commutator in a fuel pump.
DSO
All inputs to a control module must be ___________ to process data.
Digital
The fastest data bus class rating is D.
False
The most common way to control a fuel injector is on the power side.
False
Voltage ramping is the measurement that can be made to diagnose the electric circuit of a fuel pump.
False
Processing includes comparing output data from a lookup table.
False input data is compared from a lookup table
CAN stands for communication activated network.
False it stands for controller area network
Coolant temperatures, throttle position and intake air temperature are all examples of outputs.
False they create inputs
A DSO can be used to diagnose a commutator in a ___________.
Fuel pump
Information sent from modules such as the ABS or SRS are considered _____________ priority.
Highest
Most modern fuel pumps are typically ___________________ controlled using pulse width modulation.
PCM
The ____________ controls the transmission, ignition, and fuel injectors.
PCM
Most IACs use either a ____________ or a stepper motor.
PWM solenoid
Fuel pump __________________ can be calculated from the scope pattern.
RPM
Class _______ is used for critical systems such as the airbags.
class c
Drivers serve to _____________, _______________, or ____________________ from the processor.
cleanup, convert, or amplify electrical signals
The __________ can be pulse width modulated by the driver circuit internal to the computer.
idle control valve
The information sent from _________________________ are considered highest priority.
modules such as the ABS or SRS
If communication cannot be established between multiple modules, you most likely have an issue with the _________________.
network
Electronic _______________ are shifted and have fluid pressure controlled by solenoids.
transmissions
The tool you would use to check a PWM controlled solenoid is a DSO.
True
Most _____ use either a PWD solenoid or a stepper motor.
IACs
IACs stands for ___________.
Idle air control valve
___________________ of the powertrain control module is known as OBD.
Self diagnosis
If one module fails in a CAN data bus this could cause other modules to still communicate.
True
Issues within the network could could cause communication not to be established between multiple modules.
True
The idle control valve can be pulse width modulated by the driver circuit internal to the computer.
True
