Hybrid-Electrical Applications (AD12-105-2.0.1) UNIT 5 QUIZ STUDY GUIDE

अब Quizwiz के साथ अपने होमवर्क और परीक्षाओं को एस करें!

The CAN communication network uses ______________.

2 wires

Electronic transmissions are __________________________.

Are shifted and have fluid pressure controlled by solenoids.

The ___________ communication network uses 2 wires.

CAN

A __________ can be used to diagnose a commutator in a fuel pump.

DSO

All inputs to a control module must be ___________ to process data.

Digital

The fastest data bus class rating is D.

False

The most common way to control a fuel injector is on the power side.

False

Voltage ramping is the measurement that can be made to diagnose the electric circuit of a fuel pump.

False

Processing includes comparing output data from a lookup table.

False input data is compared from a lookup table

CAN stands for communication activated network.

False it stands for controller area network

Coolant temperatures, throttle position and intake air temperature are all examples of outputs.

False they create inputs

A DSO can be used to diagnose a commutator in a ___________.

Fuel pump

Information sent from modules such as the ABS or SRS are considered _____________ priority.

Highest

Most modern fuel pumps are typically ___________________ controlled using pulse width modulation.

PCM

The ____________ controls the transmission, ignition, and fuel injectors.

PCM

Most IACs use either a ____________ or a stepper motor.

PWM solenoid

Fuel pump __________________ can be calculated from the scope pattern.

RPM

Class _______ is used for critical systems such as the airbags.

class c

Drivers serve to _____________, _______________, or ____________________ from the processor.

cleanup, convert, or amplify electrical signals

The __________ can be pulse width modulated by the driver circuit internal to the computer.

idle control valve

The information sent from _________________________ are considered highest priority.

modules such as the ABS or SRS

If communication cannot be established between multiple modules, you most likely have an issue with the _________________.

network

Electronic _______________ are shifted and have fluid pressure controlled by solenoids.

transmissions

The tool you would use to check a PWM controlled solenoid is a DSO.

True

Most _____ use either a PWD solenoid or a stepper motor.

IACs

IACs stands for ___________.

Idle air control valve

___________________ of the powertrain control module is known as OBD.

Self diagnosis

If one module fails in a CAN data bus this could cause other modules to still communicate.

True

Issues within the network could could cause communication not to be established between multiple modules.

True

The idle control valve can be pulse width modulated by the driver circuit internal to the computer.

True


संबंधित स्टडी सेट्स

Biology 113 | Exam 3 (Questions)

View Set

English 12B (2020) ( Unit 1 Lessons 1-5 + EXAM)

View Set

Introduction to Kinesiology/Health/Physical Education

View Set

Positioning: Hip and Proximal Femur (CH 7)

View Set

Demonstrative Adjectives Practice #1

View Set

文法 - Be動詞過去式(was/were)

View Set