Unit 5

Ace your homework & exams now with Quizwiz!

An autotransformer uses the same winding as the primary transformer, but doesn't bit use the same winding as the secondary transformer.

False

Autotransformers rarely have multiple taps to provide different voltages.

False

If the number of primary turns is the sum of the turns between taps (such as 80 + 100 + 60 = 240 turns), and 120 volts are connected across the 240 turns, this transformer will have a volts-per-turn ration of 2.0

False

If the primary section of a transformer is connected across part of a winding, and the secondary is connected across the entire winding, the secondary section contains more windings than the primary. This is a step down transformer.

False

The amount of current flow in a secondary circuit can be computed using the formula I = Z/E

False

The primary current can be computed by using the same formula that is used to compute primary current for an isolation-type transformer.

False

An autotransformer is literally a self transformer

True

Autotransformers, like isolation transformers, can be used as a step up or step down transformer.

True

The amount of power input and output for an autotransformer must be the same.

True

The autotransformer's one disadvantage can cause problems with certain types of equipment and must be s consideration when designing a power system.

True

Autotransformers have high efficiencies, most in the range of what percent?

95-98%

Current for primary can be computed by what formula?

Ep/Es = Is/Ip

If the amount of voltage applied to the load is to be computed, which formula can be used?

Ep/Es = Np/Ns

To calculate the current flow supplied to the primary, use the formula Ip =

Is/Ratio

The autotransformer has one disadvantage: Since the load is connected to one side of the power line, there is no what between the incoming power and the load?

No line isolation

The volts-per-then for any transformer is determined by the what?

Primary winding

If a rotary switch were to be removed and replaced with a sliding tap that made contact directly with the transformer winding, the turns ratio could be adjusted continuously. This type of transformer is commonly referred to as a what? Depending on the manufacturer

Variac or Powerstat


Related study sets

Unit 3: Tin Pan Alley, Sinatra, The Jazz Era, and Swing

View Set

Income State and Statement of Stockholders' Equity Chapter-3

View Set

Ch. 21 theory of metal machining

View Set

Lesson 3 Review (MS Word Project)

View Set

Integument Layers and Subcutaneous Layer

View Set

Psych Midterm 2 Ch 8: Mood Disorders

View Set

U.S. History Chapter 4 Test Review

View Set

AP World History Chapter 5 - The Classical Period: Directions, Diversities, and Declines by 500 C.E.

View Set

Structural Change & Productivity

View Set

PrepUs for Pediatrics Chapter 23

View Set